English - Kenwood AT281 Bedienungsanleitungen

121160 Iss 1 AT281_AT286 Multi 6 page:18286 Iss 2 HB750 multi
AT281 AT285
AT286
A5 26/2/13 08:34 Page 4
before using your Kenwood attachments
Read these instructions carefully and retain for future
G
reference.
G Remove all packaging and any labels.
G Wash the parts: see 'care and cleaning'.
safety
G Refer to your main kitchen machine instruction book
for additional safety warnings.
G When using an attachment also read the safety
information included in this manual relating to that
particular product.
G This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation
no. 1935/2004 of 27/10/2004 on materials intended
for contact with food.
attachments
Not all of the attachments listed will
necessarily be included with your kitchen
machine. Attachments are dependent upon
the model variant.
Multi food grinder AT281
(if
supplied)
Use the multi food grinder to process raw and cooked
meat; fish and nuts.
safety
G Always ensure bones and rind etc are removed from
the meat before mincing.
G When mincing nuts only feed a few down at a time
and allow the scroll to pick them up before adding
any more.
G Always use the pusher supplied. Never put your
fingers or utensils in the feed tube.
Warning - the cutting blade is sharp, handle with care
G
both in use and when cleaning.
G Ensure the attachment is secured in position before
switching on.
key
ring nut
multi food grinder screens: medium, coarse (due to
model variants only 1 screen may be supplied)
cutter
scroll
multi food grinder body
tray
pusher
to assemble
1 Fit the scroll inside the multi food grinder body.
2 Fit the cutter – cutting side outermost . Ensure it's
seated properly – otherwise you could damage your
multi food grinder.
3 Fit a multi food grinder screen . Put the notch over
the pin.
4 Loosely fit the ring nut.
to use the multi food grinder
1 Raise the mixer head.
2 With the multi food grinder in the position shown ,
align the drive tabs on the end of the scroll with the
corresponding slots in the drive outlet.
3 Push the multi food grinder into the outlet and turn
clockwise until it locks into place.
4 Tighten the ring nut manually.
5 Fit the tray .
6 Thaw frozen food thoroughly before
mincing. Cut meat into 2.5cm (1") -wide strips.
3