Description; Overview; Safety; Installation - GreenWorks CSC401 Bedienungsanleitung

1

DESCRIPTION

1.1

OVERVIEW

Figure 1-22
Guide bar cover
1
Front handle
2
guard / chain brake
Front handle
3
Lock out button
4
Trigger
5
Oil tank cap
6
Oil indicator
7
Spike bumpers
8
Saw chain
9
10 Guide bar
11 Wrench
12 Rear handle
13 Chain tension
screw
14 Chain cover
15 Chain cover nuts
16 Bolt for saw chain
tension
17 Sprocket
18 Battery release
button
19 Oil outlet
20 Bar groove
21 Chain drive links
22 Cutter
23 Felling direction
2

SAFETY

WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

WARNING
Do not change or make accessories that are not
recommended by the manufacturer.
WARNING
Do not put in the battery pack until you assemble all
the parts.
English
24 Danger zone
25 Escape route
26 Direction of fall
27 Notch
28 Felling back cut
29 Hinge
30 Limb cut
31 Keep work off
ground leave
support limbs until
log is cut
32 Log supported
along the entire
length
33 Cut from top (over
buck) avoid cutting
earth
34 Log supported one
end
35 Under buck
36 Over buck
37 Log supported both
ends
38 Bucking a log
39 Stand on uphill side
when cutting
because log may
roll
3.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 1-7.
1. Remove the chain cover nuts with the wrench.
2. Remove the chain cover.
3. Put the chain drive links into the bar groove.
4. Put the chain cutters in the direction of the chain
operation.
5. Put the chain in position and make sure that the
loop is behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket.
8. Make sure the chain tension pin hole on the guide
bar fits correctly with the bolt.
9. Install the chain cover.
10. Tighten the chain. Refer to
11. Tighten the nuts when the chain is well tensioned.
If you start the chain saw with a new chain, have a test
for 2-3 minutes. A new chain gets longer after the first
use, examine the tension and tighten the chain if
necessary.
3.3

INSTALL THE BATTERY PACK

Figure 2
5
Adjust the chain tension.
NOTE
EN