Troubleshooting - Yamaha NX-P100 Bedienungsanleitung

TROUBLESHOOTING

If this unit malfunctions, see the following troubleshooting first. If you encounter a problem that is not described below or if this unit
still malfunctions after the following solutions are implemented, turn off the power of the unit and contact the nearest authorized
Yamaha dealer or the service center.
General
Problem
No sound.
Even if the volume is raised, the
sound level will not increase.
The LED indicator is blinking
rapidly.
This unit does not work at all.
Cause
The connection between this unit and the connecting
device is not correct.
The volume on this unit or the connecting device is set
to the minimum.
The battery in this unit is weak.
The protection circuitry has been activated by the
excessive volume.
The volume on the connecting device is low.
The battery in this unit is weak.
The battery in this unit is weak.
The unit may have received a strong electrical shock
such as lightning or excessive static electricity.
Solution
Establish the connection again (☞ P. 4).
Raise the volume on this unit and the connecting
device.
Recharge the battery (☞ P. 3).
Lower the volume.
Raise the volume on the connecting device.
Recharge the battery (☞ P. 3).
Recharge the battery (☞ P. 3).
Reset this unit by holding down the
button for ten seconds or more.
Reset has completed when the LED indicator is lit in
white for a moment after you released the button.
Wait for three seconds or more, and then turn on the
power of this unit.
(Power)
10