Troubleshooting; Maintenance And Repair; Notices - Vieweg 990268-X Bedienungsanleitung

VIEWEG
Dispenser DP
5.

Troubleshooting:

5 Troubleshooting
Problem
Problem
Plunger discs cannot
Plunger discs cannot
enter the cartridge
enter the cartridge
EN
The cartridge cannot
be removed from the
The cartridge cannot
be removed from the
dispenser
dispenser.
6.

Maintenance and repair:

6 Maintenance and repair

6.1 Notices

Notices
22905825v3
2009-03 (V 2.0)
Potential Cause
Potential Cause
Cartridge not fully
Cartridge not fully
inserted in cartridge
inserted in cartridge
bed
bed
The plunger discs are
still in position inside
The plunger discs are
.
still in position inside
the cartridge
the cartridge.
All maintenance and repairs must only be carried out by
sites authorized by the manufacturer and exclusively by
qualified and suitably trained personnel.
Always disconnect the compressed air supply from the
dispenser during maintenance and repairs.
Never open the pneumatic drive unit. If the pneumatic
drive unit is or appears to be in need of maintenance or
repair, contact a Sulzer Mixpac authorized Service Center.
Keep the dispenser clean at any time. Failure to do so
may result in malfunction of dispenser or bodily
injury.
Do not use aggressive cleaning products to clean the
surface of the device.
Operating Manual 990268-X
Remedy
Lösung
Check that there is
Check that there is
no foreign matter in
no foreign matter in
the cartridge bed.
the cartridge bed. Push the cartridge
fully down into the
Push the cartridge
cartridge bed. Mind
fully down into the
your fingers.
cartridge bed. Mind
your fingers.
Press the red button
to fully retract the
Press the red button
.
plunger discs to the
to fully retract the
back end-stop.
plunger discs to the
back end-stop.
20
10
Sulzer Mixpac AG