Herunterladen Inhalt Inhalt Diese Seite drucken

Use; Switching The Appliance On And Off; Switching The Work Lamp On And Off; Setting Rotational Speed - Parkside PMB 1100 A1 Originalbetriebsanleitung

Metallbandsäge
Vorschau ausblenden Andere Handbücher für PMB 1100 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
NOTE
Make sure that the direction arrow on the
saw blade
(if any) is the same as the one
on the rubber wheels
Insert the saw blade
wheels.
Retighten
the saw blade clamping lever
turning it clockwise
Replace the two protective covers
WARNING! RISK OF INJURY!
Only operate the appliance with the
protective covers fitted
Perform a test run by briefly switching the ap-
pliance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
Keep your body away from the sawing
area during the test run!

Use

Switching the appliance on and off
Switching on:
Hold down the On/Off switch
Switching off:
Release the On/Off switch
Switching the work lamp on and off
Switching on:
Move the light switch
The work lamp
lights up.
Switching off:
Move the light switch
The work lamp
goes out.

Setting rotational speed

Adjust the speed setting wheel
between 1 and 6.
PMB 1100 A1
.
around the two rubber
again.
.
!
.
.
to position I.
to position 0.
to a position

Working procedures

Secure the workpiece against slipping, e.g. with
the vice
of the saw table.
Use the weight of the saw when sawing.
Do not exert any additional pressure.
Wait until the saw has reached its full speed
before carefully bringing it into contact with the
by
workpiece.
If the saw blade
ance immediately.
Do not twist the saw blade
the cut.
WARNING! RISK OF INJURY!
Do not remove the workpiece until the saw
has come to a standstill.

Cleaning and maintenance

WARNING! RISK OF INJURY!
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
Store the appliance and the saw blades in a
dry and dust-free location.
The appliance must always be clean and free
of oil or grease.
Use a soft, dry cloth to clean the housing.
The carbon brushes should only be replaced
by the service centre or an authorised specialist
workshop.
Never obstruct the ventilation openings.
Remove any adhering sawdust with a brush.
NOTE
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
blocks, switch off the appli-
while making
GB │ IE
 19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis