Mains Operation; Battery Operation; Environmental­note - Grundig RCD 1500 BT Handbuch

POWER­SUPPLY­______________________________
Mains­operation
Note:­
Check that the mains voltage on the type plate
7
corresponds to your local mains supply.
If this is not the case, contact your specialist dealer.
7
1 Plug the mains cable supplied into the
socket on the radio (back of device).
2
Plug the mains cable into the wall socket.
Caution:
The device is connected to the mains with the
7
power plug. To fully disconnect the device from
the mains, pull out the plug.
The mains plug is used to disconnect the device. It
7
shall remain readily operable and should not be
obstructed during intended use.
Battery­operation
1 Open the battery compartment by pressing the catch
and removing the lid.
2
Insert six batteries (6 x 1.5 V/type IEC R14/UM2/
C-size), observing the polarity marked on the lid of
»AC « the battery compartment.
~
3­
Close the battery compartment.
Notes:­
Do not expose the batteries to extreme heat,
7
caused for example by direct sunlight, heaters or
fire.
Remove the batteries when they are flat or when
7
you know that the device will not be used for a
long period of time.
The manufacturer accepts no liability for damage
7
resulting from leaking batteries.
The batteries are switched off during mains op-
7
eration.
Environmental­note:
Batteries, including those which contain no heavy
7
metal, may not be disposed of with household
waste. Please dispose of used batteries in an en-
vironmentally sound manner. Find out about the
legal regulations which apply in your area.
21­
ENGLISH