Switching On And Off; Setting The Speed; Changing A Disc - Parkside PWS 1200 Bedienungs- Und Sicherheitshinweise

Use

Switching on and off

Check the attached consumable or tool before use.
It must be attached properly, not damaged, damp
or cracked and must rotate freely. Test the opera-
tion of the device for 30 seconds. If a disc is not
round or vibrates, do not use it.
Look out for unusual noises or generation of sparks.
Check that all the fastenings are correctly attached.
The device is fitted with an IPC electronic start-up
system. After you press the ON/OFF switch
there is a delay before the motor starts.
Switching on:
j Press the ON/OFF switch
Switching off:
j Release the ON/OFF switch
Locking:
j Press the lock button
holding down the ON/OFF switch
Releasing the lock:
j Press the ON/OFF switch
m Attention: Wait until the electric motor has
come to a complete standstill before you press the
spindle lock button .
10

Setting the speed

j To increase the speed, turn the rotation speed
preselector wheel
11
(6 = highest speed) setting.
j To decrease the speed, turn the rotation speed
preselector wheel
11
(1 = lowest speed) setting.
36 GB/MT
3
.
3
again.
3
whilst pressing and
1
.
3
again.
3
towards the 6
towards the 1

Changing a disc

J
Always wear protective gloves when
changing cutting or roughing/grind-
ing discs.
j Press the spindle lock button
mounting spindle
8
Fig. B.
j Press the spindle lock button
drive.
j Release the clamping nut
, Fig. C.
12
j Place the roughing, grinding or cutting disc on
to the mounting flange
facing towards the device.
j Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
8
j Press the spindle lock button
drive.
j Tighten the clamping nut
spanner .
12
Note: Replace a new disc immediately if it
runs unevenly or vibrates after being ex-
changed.
j After replacing a disc let the device run under
no load for 30 seconds as a safety check. Look
out for unusual noises or generation of sparks.
j Check that all the fastenings are correctly
attached.
j Pay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
only after the
10
has reached a standstill,
to block the
10
using the spanner
7
with its labelled side
9
, with its
7
to block the
10
again with the
7