Careful Handling And Use Of Electrical Tools; Safety Advice Relating Specifically To This Device - Parkside PHKS 1450 LASER Bedienungs- Und Sicherheitshinweise

4. Careful handling and use of
electrical tools
a) Do not overload the device. Always
use an electrical power tool that is in-
tended for the task you are undertak-
ing. By using the right electrical power tool for
the job you will work more safely and achieve
a better result.
b) Do not use an electrical power tool if
its switch is defective. An electrical pow­
er tool that can no longer be switched on and
off is dangerous and must be repaired.
c) Pull the mains plug from the socket
before you make any adjustments to
the device, change accessories or when
the device is put away. This precaution is
intended to prevent you from unintentionally
starting the device.
d) When not in use always ensure that
electrical power tools are kept out of
reach of children. Do not let anyone
use the device if he or she is not famil-
iar with it or has not read the instruc-
tions and advice. Electrical power tools are
dangerous when they are used by inexperienced
people.
e) Look after the device carefully.
Check that moving parts are working
properly and move freely. Check for
any parts that are broken or dam-
aged enough to detrimentally affect
the functioning of the device. Have
damaged parts repaired before you
use the device. Many accidents have their
origins in poorly maintained electrical power
tools.
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, acces-
sories, inserted tools etc. in accord-
ance with these instructions and ad-
vice, and the stipulations drawn up
for this particular type of device. In
doing this, take into account the
PHKS_1450_Content_LB5.indd 37
General safety advice
working conditions and the task in
hand. The use of electrical power tools for
purposes other than those intended can lead to
dangerous situations.
Safety advice relating
specifically to this device
J
Ensure that the device is always used in accord­
ance with the advice in these operating instruc­
tions and only by persons over 16 years of age.
note: Do not use grinding discs. Failure to ob­
serve this advice may result in injury or damage.
to avoid danger to life from
electric shock:
J
Frequently check the condition of the
device, mains lead and plug.
Do not use the device if these kinds
of parts are damaged. Never open up the device.
A damaged device, mains lead or plug presents a
serious danger to life from electric shock.
Always have any repairs carried out or re­
placement parts fitted at the service centre or
by an electrical equipment repair specialist.
J
Devices marked with 230 V can also be oper­
ated at 220 V.
J
Do not operate the device if it is damp and do
not use it in a damp environment.
J
If you use the device outdoors, always connect
it through a residual current device (RCD) with
a maximum trip current of 30 mA. If using an
extension lead, always use one that is approved
for outdoor use.
note: Always keep the mains lead away from the
working area of the machine and lead away the
mains lead from the rear.
CAUtIOn! to avoid the
risk of injury:
a) Keep your hands away from the
area around the saw and clear of the
GB/MT 37
30.07.2008 15:15:22 Uhr