Parkside PZKS 1500 B2 Bedienungs- Und Sicherheits Hinweise, Originalbetriebsanleitung Seite 19

coatings, some wood types, minerals and
metal can be harmful to one's health.
Touching or breathing-in the dust can cause
allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dust, such as oak or beech dust,
is considered carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
- Always use dust extraction.
- Provide for good ventilation of the
working place.
- It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Prevent dust accumulation at the
workplace. Dust can easily ignite.
The dust/chip extraction can be blocked by
dust, chips or workpiece fragments.
- Switch the machine off and pull the mains
plug from the socket outlet.
- Wait until the saw blade has come to a
complete stop.
- Determine the cause of the blockage and
correct it.
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 35 mm) can also be connected to the dust
extraction spout.
- Connect the vacuum hose with the dust
extraction spout .
The vacuum cleaner must be suitable for
the material being worked.
When vacuuming dry dust that is
especially detrimental to health or
carcinogenic, use a special vacuum
cleaner.
The saw is equipped with a sawdust bag (21)
for sawdust and chips.
Squeeze together the metal ring on the dust
14 GB / IE / NI
Attachment and operation
bag and attach it to the outlet opening in the
motor area.
The sawdust bag (21) can be emptied by
means of a zipper at the bottom.
8.12 Changing the saw blade
(Fig. 1/17/18/19/20)
• Allow the machine head (4) to rise to the
upright position.
• Loosen the cover plate screw with the
4 mm Allen key (e).
WARNING! Do not remove this screw.
• Rotate the cover plate (20) upward and
raise the movable blade guard to the
upper position to expose the flange bolt
(35).
• Place the 6 mm Allen key (d) over the
flange bolt.
• Press the saw shaft lock (37), holding
it in firmly while turning the 6mm Allen
key (d) clockwise. The shaft lock will be
engage after turning the 6mm Allen key.
• Continue to hold the saw shaft lock to
keep it engaged, while turning the blade
Allen key clockwise to loosen the flange
bolt (35).
• Remove the flange bolt (35) and the
outer flange (36).
• Take the saw blade (6) off the inner
flange (38) and pull out downwards.
NOTE: Pay attention to the pieces
removed, noting their position and
direction they face.
• Carefully clean the flange bolt (35), outer
flange (36) and inner flange (38).
• Fit and fasten the new saw blade (6) in
reverse order.
• Important! The cutting angle of the teeth,
in other words the direction of rotation of
the saw blade (6) must coincide with the
direction of the arrow on the housing.
• Rotate the cover plate (20) downward
and lower the movable blade guard to
the lower position to cover the flange bolt
(35).