Parkside PZKS 1500 B2 Bedienungs- Und Sicherheits Hinweise, Originalbetriebsanleitung Seite 11

11 Do not use the cable for purposes for
which it is not intended
- Do not use the cable to pull the plug out
of the outlet. Protect the cable from heat,
oil and sharp edges.
12 Secure the workpiece
- Use the clamping devices or a vice to
hold the workpiece in place. In this
manner, it is held more securely than with
your hand.
- An additional support is necessary for
long workpieces (table, trestle, etc.) in
order to prevent the machine from tipping
over.
- Always press the workpiece firmly
against the working plate and stop in
order to prevent bouncing and twisting of
the workpiece.
13 Avoid abnormal posture
- Make sure that you have secure footing
and always maintain your balance.
- Avoid awkward hand positions in which
a sudden slip could cause one or both
hands to come into contact with the saw
blade.
14 Take care of your tools
- Keep cutting tools sharp and clean in
order to be able to work better and more
safely.
- Follow the instructions for lubrication and
for tool replacement.
- Check the connection cable of the electric
tool regularly and have it replaced by a
recognised specialist when damaged.
- Check extension cables regularly and
replace them when damaged.
- Keep the handle dry, clean and free of
oil and grease.
15 Pull the plug out of the outlet
- Never remove loose splinters, chips or
jammed wood pieces from the running
saw blade.
- During non-use of the electric tool or prior
to maintenance and when replacing tools
such as saw blades, bits, milling heads.
16 Do not leave a tool key inserted
- Before switching on, make sure that keys
6 GB / IE / NI
and adjusting tools are removed.
17 Avoid inadvertent starting
- Make sure that the switch is switched off
when plugging the plug into an outlet.
18 Use extension cables for outdoors
- Only use approved and appropriately
identified extension cables for use
outdoors.
- Only use cable reels in the unrolled state.
19 Remain attentive
- Pay attention to what you are doing.
Remain sensible when working. Do
not use the electric tool when you are
distracted.
20 Check the electric tool for potential
damage
- Protective devices and other parts must
be carefully inspected to ensure that they
are fault-free and function as intended
prior to continued use of the electric tool.
- Check whether the moving parts function
faultlessly and do not jam or whether
parts are damaged.
All parts must be correctly mounted and
all conditions must be fulfilled to ensure
fault-free operation of the electric tool.
- The moving protective hood may not be
fixed in the open position.
- Damaged protective devices and parts
must be properly repaired or replaced
by a recognised workshop, insofar
as nothing different is specified in the
operating manual.
- Damaged switches must be replaced at a
customer service workshop.
- Do not use any faulty or damaged
connection cables.
- Do not use any electric tool on which the
switch cannot be switched on and off.
21 ATTENTION!
- Exercise elevated caution for double
mitre cuts.
22 ATTENTION!
- The use of other insertion tools and other
accessories can entail a risk of injury.
23 Have your electric tool repaired by a
qualified person.
Safety information