Herunterladen Diese Seite drucken
Mitsubishi Electric OL-XL2550MZ Handbuch
Mitsubishi Electric OL-XL2550MZ Handbuch

Mitsubishi Electric OL-XL2550MZ Handbuch

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

オプションレンズ
OL-XL2550MZ
レンズ交換要領書
このオプションレンズは三菱電機 (株) 製 LVP-MH2850 に使用できます。レンズ交換は、必ず教育を受けた専門業者に依頼してください。その他の
機種について、またはご不明な点がありましたら、販売店にご相談ください。
● レンズ交換する前には、必ず電源を切り、電源プラグをコンセントから抜いてください。
● 電源を切ってから1時間以内にはレンズ交換を行わないでください。
● レンズ交換時には、ゴミが内部に入らないように注意してください。
レンズ交換のしかた
以下の手順にしたがってレンズ交換を行ってください。
A. レンズカバーの取りはずしかた
1. レンズキャップ A をはずす
2. ネジ B(2 本)をはずす
3. レンズカバー C をはずす
B. レンズの取りはずしかた
1. ネジ D(4 本)をレンズを保持しながらゆるめる
2. 矢印 E の方向にレンズをはずす
C. 交換レンズの取り付けかた
1. 矢印 F の方向にレンズを取り付ける
2. ネジ D(4 本)をレンズを保持しながら締める
D. レンズカバーの取り付けかた
はずしたときと反対の手順で取り付ける
レンズ交換後の確認について
● すべての部品が確実に取り付けられているか確認してください。
● 投写映像にゴミが映っていないか確認してください。ゴミが映ってい
る場合は、ゴミを清掃してください。
レンズ交換後の注意点
● レンズ交換後は、プロジェクター本体の輸送はしないでください。
プロジェクター本体が破損するおそれがあります。
● レンズ交換後は、投写映像の明るさ、解像度、色均一性が標準レンズ
装着時と異なることがあります。
● レンズ交換後の台形補正は、補正角度の範囲が標準レンズ装着時と異
なることがあります。
● レンズ交換後の台形補正は、画面が正しいアスペクト比にならないこ
とがあります。
仕様
対応機種
三菱電機 (株) 製 LVP-MH2850
F 値
F1.7 ∼ F2.0
焦点距離
f = 29 ∼ 37mm
ズーム/フォーカス
手動(ズーム比 1.3:1)
投写画面
40 形 (81cm × 61cm)∼ 300 形 (610cm × 457cm)
画面 サイズ
投写距離 L
高さ H1
(cm)
(形)
幅 W(cm)高さ H (cm) 最短(m) 最長(m)
40
81
61
1.4
1.8
60
122
91
2.1
2.7
80
163
122
2.9
3.7
100
203
152
3.6
4.6
150
305
229
5.4
6.9
200
406
305
7.3
9.3
250
508
381
9.1
300
610
457
10.9
● 表示値は、実際とは数%誤差が生じることがあります。
A-1, 2, 3
B-1, C-2
D
C
D
B
A
B
B-2, C-1
E
F
して取り付けてください。
W
6
9
12
15
23
31
38
46
OPTION LENS
日本語
OL-XL2550MZ
Lens Replacement Manual
This option lens is available for the Mitsubishi HL2750U, MH2850U and WL2650U. Lens replacement must be performed by service
personnel. For all other models or product related questions, contact your local dealer.
Be sure to turn off the projector and unplug the power cord from the wall outlet before the lens replacement.
Do not replace the lens for at least 1 hour after power off.
When replacing the lens, be careful not to allow dust to enter inside.
Lens replacement procedure
To replace the lens from the projector, carefully follow steps A through D.
A. Remove the lens cover
1. Remove the lens cap A.
2. Remove the screws B (2 screws) on the front cabinet.
D
3. Remove the lens cover C from the front cabinet.
B. Remove the lens
1. Loosen the screws D (4 screws) while holding the lens.
2. Remove the lens in the direction of arrow E.
C. Mount the lens
D
1. Mount the lens in the direction of arrow F.
2. Tighten the screws D (4 screws) while holding the lens.
D. Mount the lens cover
Mount the lens cover in the reverse procedure of removal.
Check and confi rm after the lens replacement
There should be no missing parts, or any loose mounting parts.
Make sure that there is no visible dust on the projected image. Clean it, if any.
Cautions after lens replacement
Do not transport the projector after replacing the lens. The projector may be broken.
Brightness, resolution, and color uniformity in the projected image with a new lens may be different from those with the standard lens.
The adjustable angle in the keystone adjustment with a new lens may differ from that with the old lens.
In the keystone adjustment after lens replacement, the proper aspect ratio may not be obtained.
Specifi cations
ラベルが貼ってある側を上に
Applicable models Mitsubishi HL2750U, MH2850U, WL2650U
F No.
Focal distance
Zoom/focus
Picture size
Screen size and projection distance
(1) HL2750U, MH2850U
Screen size
Diagonal size
Width (W)
inch
cm
inch
40
102
32
60
152
48
80
203
64
100
254
80
150
381
120
200
508
160
250
635
200
300
762
240
(2) WL2650U
Screen size
Diagonal size
Width (W)
inch
cm
inch
40
102
34
L
60
152
51
80
203
68
100
254
85
150
381
127
200
508
170
250
635
212
300
762
254
• The above numbers are approximate, and may be slightly different from the actual measurements.
F1.7 - F2.0
f = 29 - 37 mm
Manual drive (zoom ratio 1.3 : 1)
40 inch (81 cm X 61 cm) - 300 inch (610 cm X 457 cm) (HL2750U, MH2850U)
40 inch (86 cm X 54 cm) - 300 inch (646 cm X 404 cm) (WL2650U)
Projection distance (L)
Height (H1)
Height (H)
Shortest (Wide) Longest (Tele)
cm
inch
cm
inch
m
inch
m
inch
cm
81
24
61
55
1.4
71
1.8
2.4
6
122
36
91
84
2.1
108
2.7
3.6
9
163
48
122
113
2.9
145
3.7
4.8
12
203
60
152
142
3.6
182
4.6
6.0
15
305
90
229
214
5.4
274
6.9
9.0
23
406
120
305
285
7.3
366
9.3
12.0
31
508
150
381
357
9.1
-
-
15.0
38
610
180
457
429
10.9
-
-
18.0
46
Projection distance (L)
Height (H1)
Height (H)
Shortest (Wide) Longest (Tele)
cm
inch
cm
inch
m
inch
m
inch
cm
86
21
54
58
1.5
75
1.9
0.5
1
129
32
81
89
2.3
114
2.9
0.8
2
172
42
108
119
3.0
152
3.9
1.1
3
215
53
135
149
3.8
191
4.9
1.3
3
323
79
202
224
5.7
287
7.3
2.0
5
431
106
269
300
7.6
384
9.8
2.6
7
538
132
337
375
9.5
-
-
3.3
8
646
159
404
453
11.5
-
-
3.9
10
MITSUBISHI ELECTRIC CORPORATION
1 Zusho Baba, Nagaokakyo-City, Kyoto Japan
ENGLISH
A-1, 2, 3
B-1, C-2
D
D
C
D
D
B
A
B
B-2, C-1
E
Attach the option
F
lens with its label up.
W
L

Werbung

loading

Inhaltszusammenfassung für Mitsubishi Electric OL-XL2550MZ

  • Seite 1 Shortest (Wide) Longest (Tele) inch inch inch inch inch inch − 10.9 − ● 表示値は、実際とは数%誤差が生じることがあります。 11.5 • The above numbers are approximate, and may be slightly different from the actual measurements. MITSUBISHI ELECTRIC CORPORATION 1 Zusho Baba, Nagaokakyo-City, Kyoto Japan...
  • Seite 2 OBJECTIF EN OPTION ZUSATZLINSE FRANÇAIS DEUTSCH OL-XL2550MZ OL-XL2550MZ Instructions pour le Remplacement de l’Objectif Handbuch zum Austausch der Linse Diese optionale Linse ist für den Mitsubishi HL2750U, MH2850U und WL2650U im Handel erhältlich. Der Austausch der Linse muss Cet objectif optionnel est disponible pour le Mitsubishi HL2750U, MH2850U et WL2650U. Le remplacement de l’objectif doit être durch den Kundendienst durchgeführt werden.
  • Seite 3 选购镜头 中文 OL-XL2550MZ 镜头更换手册 本选购镜头仅适用于三菱 HL2750U、 MH2850U 以及 WL2650U 。必须由专业的维修人员进行镜头更换工作。关于其它型号或产品相关问题, 请垂询当地经销商。 更换镜头前,请务必关闭投影机并从插座拔下电源线。 • 必须在关闭投影机后至少等待一个小时,方可更换镜头。 • 更换镜头时,小心尘土进入。 • A-1、2、3 B-1、C-2 镜头更换步骤 从投影机上更换镜头时,按照 A 到 D 步骤小心执行。 A. 取下镜头盖 1. 取下镜头罩 。 2. 拆下前盒盖的螺丝 (2 个螺丝) 。 3. 从盒盖取下镜头盖 。 B. 取下镜头...