Use; Additional Handle; Depth Stop; Changing Tools - Parkside PSBM 750 B3 Originalbetriebsanleitung

Use

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ Loosen the strap on the additional handle
turning it clockwise.
♦ Push the additional handle
the quick release chuck
♦ Turn the additional handle
position.
♦ The locking positions on the additional handle
must now be pushed over the locking pin on
the spindle of the appliance.
♦ Turn the additional handle
again to tighten it.
NOTE
► Move the additional handle
various locking positions depending on your
working position. Undo and lock the addition-
al handle as described previously.

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in.
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required drill-
ing depth.
♦ Release the locking button for the depth stop
to lock the depth stop
│ GB │ MT
■ 36
in the direction of
.
to the required
anticlockwise
into the
into the additional
out until the distance
.

Changing tools

♦ Turn the quick-release chuck
RELEASE
to open it.
♦ Insert the desired tool into the quick-release
chuck .
♦ Turn the quick-release chuck
to tighten the tool.

Operation

Select operating mode

Function selector switch:
by
♦ Push the function selector switch
engages at the required symbol:
Function
Drilling
Impact drilling

Select direction of rotation

WARNING!
► The rotation direction switch
be used/adjusted if the appliance is at a
standstill.
♦ Select the direction of rotation by pressing the
rotation direction switch
right.

Preselecting the rotation speed

You can use the rotational speed preselector
adjusting wheel
speed. The speed you select depends on the
material to be processed. Work out the right
setting by carrying out a practice test.:
NOTE
► The appliance only reaches the set rotational
speed during continuous operation.
towards
towards
so that it
Symbol
may only
towards the left or
to preselect the rotational
PSBM 750 B3
GRIP