Use; Using The Product Without A Power Connection; Corded Use Of The Product; Fixing The Product - Parkside PTLL 1 A1 Bedienungs- Und Sicherheitshinweise

Note: The product is fitted with an overcharge
protection circuit. Despite this, you should dis-
connect the LED inspection lamp from the power
supply after the charging process is complete.
Note: During charging, the charging indicator
(LED torch) lights up red. When charging
3
is complete, the charging indicator (LED torch)
lights up green. When the charging indi-
3
cator (LED torch)
adaptor out of the socket. Disconnect the
11
mains adaptor
11
the rechargeable battery from discharging.

Use

Q
CAUTION! RISK OF ACCIDENT! Always
store and secure the product in such a way that there
is no risk of injury from or damage to the product.
Note: The product features magnets
back. Ensure the metallic surface is sufficiently
magnetisable to carry the weight of the product,
before you use the magnets
U sing the product without
a power connection
F ully charge the product as described in the
section "Charging the product".
P ress the ON / OFF switch
inspection light
2
P ress the ON / OFF switch
the torch on and the inspection light
1
will turn off at the same time.
P ress the ON / OFF switch
the entire product will be switched off.

Corded use of the product

U se the included mains adaptor
pose. Using the respective mains adaptor
connect the product to a suitable power supply.
T hen proceed as described under "Using the
product without a power connection" (starting
with step 2).
16 GB/IE
is green, pull the mains
3
from the product to prevent
on the
6
.
6
to turn the
4
on.
again to turn
4
2
the third time,
4
for this pur-
11
Note: The product can only be charged
whilst off!

Fixing the product

Q
The product can be used in 2 ways without having
to hold it in your hand:
H old the magnets
surface. The product remains in this position.
F old out the hook
from a suitable suspension point. The hook
can be turned through 360 degree.
M ounting the charging station
(see fig. C)
Note: You will need an electric drill.
CAUTION! RISK OF INJURY! Please read the
operating instructions for your drill.
CAUTION! Ensure that you do not damage any
electricity cables in the wall or ceiling.
M ark the two mounting holes at a distance of
approx. 35 mm apart.
N ow drill the holes on the wall (ø approx.
6 mm; depth approx. 30 mm).
I nsert the dowels
necessary use a hammer to make this easier.
S crew up the screws
N ow hang the charging station to the screws
via the mounting holes
U se the included drill template intended for
marking the drill holes.

Maintenance and cleaning

Q
The product requires no maintenance. The LEDs
cannot be replaced.
, S witch off and disconnect the product from the
11
power supply before you clean it.
N ever immerse the product in water or other
liquids.
D o not use corrosive cleaning agents.
against a metallic magnetic
6
to suspend the product
5
into the drilled holes. If
14
on the dowels
13 14
.
12
5
.