Connection And Preparation - Grundig WMS 3000 BT DAB+ Handbuch

CONNECTION AND PREPARATION

Connecting the antenna
1
Plug the roof antenna cable into the antenna
ANTENNA« on the hi-fi system.
socket »FM
Note:
If no roof antenna is available, use the
7
auxiliary antenna supplied. When suitably
positioned and with adequate signal, this
antenna provides adequate reception of
FM channels. Do not shorten the auxiliary
antenna.
Connecting an MP3 player or a
USB memory stick
Caution:
The hi-fi system must be switched off while
7
the USB connection is being made. If it is not
switched off, data can be lost.
1
Connect the USB interface of the MP3 player
to the » « socket of the hi-fi system with a
standard USB cable;
or
insert the USB plug of the USB memory stick
into the USB interface »
tem.
Connecting external devices
Note:
Switch the hi-fi system off before you connect
7
external devices.
1 Use standard audio cables to connect the
audio outputs of the external device to the
»LINE IN« sockets on the hi-fi system.
10
ENGLISH
Connecting the power cord
1
« of the hi-fi sys-
Notes:
Check that the mains voltage on the type
7
plate (on the rear of the hi-fi system) corre-
sponds to your local mains supply. If this is
not the case, contact your specialist dealer.
All the other devices/loudspeakers must be
7
connected before you connect the power
cord.
Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains
7
with the power cord. Pull out the power plug
if you want to completely disconnect the hi-fi
system from the mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
---------------------------------------