Storage; Disposal And The Environment - Parkside PGSA 4 A1 Originalbetriebsanleitung

GB IE
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the
blades can be evened
out. For this, sand
down the blades with an oil stone.
Only sharp blades can cut properly.
• Blunt, bent or damaged blades must
be changed.
We are not liable for damage caused by
the use of the unit if the original cause was
improper repair or the use of non-original
parts or through use other than that desig-
nated in this manual.

Storage

• Keep the equipment in the blade guard
supplied, dry and out of reach of chil-
dren.
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period.
• Store the equipment between 10° C and
25° C. During storage, avoid extreme
cold or heat so the battery does not lose
power.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
32
Disposal and the
environment
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have inished with them.
Machines do not belong with domes-
tic waste.
Do not dispose of the device with
the battery installed in household
waste, ire (risk of explosion) or
water. Damaged batteries may
damage the environment and
your health if toxic fumes or liq-
uids leak out.
• Dispose of the equipment with the bat-
tery discharged. Do not open the equip-
ment or the battery.
• Dispose of the equipment in accord-
ance with the local regulations. Take the
equipment to a collection point, where
it will be recycled in an environmentally
friendly manner. For information about
this, ask your local waste management
company or our service centre. Inform
the recycling centre about the ixed-
installed rechargeable battery.
• Defective units returned to us will be dis-
posed of for free.
• Place cut branches in compost and not
in the dustbin.