Die Grinder Pgs 500 A1; Introduction; Intended Use; Features - Parkside PGS 500 A1 Originalbetriebsanleitung

DIE GRINDER PGS 500 A1

Introduction

Congratulations on the purchase of your new appli-
ance. You have chosen a high-quality product. The
operating instructions are part of this product. They
contain important information about safety, usage
and disposal. Before using the product, please famil-
iarise yourself with all operating and safety instruc-
tions. Use the product only as described and for the
range of applications specified. Please also pass
these operating instructions on to any future owner.

Intended use

The appliance is intended for grinding and deburr-
ing metal with aluminous abrasives and work with
sanding belt bodies. It is furthermore intended for
brushing and polishing metal. Any other use of or
modification of the appliance is deemed contrary
to the intended use and carries the risk of serious
personal injury. Not for commercial use.

Features

Steplessly adjustable speed control
ON/OFF switch
Power cord
Ventilation slits
Tensioning nut
Collect chuck 6 mm (pre-assembled)
Spindle lock button
Collect chuck 3.2 mm
Grinding stone
Assembly wrench

Package contents

1 die grinder PGS 500 A1
2 collet chucks
1 grinding stone
1 assembly wrench
1 plastic case
1 set of operating instructions
│ GB │ IE
■ 14

Technical data

Rated power
consumption:
Rated voltage:
Rated speed:
Chuck suspension:
Intended shaft diameter max. Ø 6 mm
Clamping
Protection class:
NOTE
► Only use accessories designed for more
than 30,000 rpm.
Noise emission value:
Noise measurement value determined in
accordance with EN 60745. The noise level of the
power tool rated A is typically the following:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Vibration emission value: a
Uncertainty K = 1.5 m/s
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
500 W
230 V ~ , 50 Hz (AC)
n 4,500–30,000 min
max. Ø 6 mm
min. 10 mm
II / (double insulation)
L = 78.4 dB (A)
PA
K = 3 dB
PA
L = 89.4 dB (A)
WA
K = 3 dB
WA
= 5.301 m/s 2
h
2
PGS 500 A1
-1