Sony HDCU2000 Betriebsanleitung Seite 11

English
Before operating the unit, please read this manual thoroughly
and retain it for future reference.
For the HDCU2000/2500
WARNING
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
THIS APPARATUS MUST BE EARTHED.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
WARNING: THIS WARNING IS APPLICABLE FOR USA
ONLY.
If used in USA, use the UL LISTED power cord specified
below.
DO NOT USE ANY OTHER POWER CORD.
Plug Cap Parallel blade with ground pin
(NEMA 5-15P Configuration)
Cord Type SJT, three 16 or 18 AWG wires
Length Minimum 1.5 m (4 ft. 11 in.), less than 2.5 m
(8 ft. 3 in.)
Rating Minimum 10 A, 125 V
Using this unit at a voltage other than 120V may require the
use of a different line cord or attachment plug, or both. To
reduce the risk of fire or electric shock, refer servicing to
qualified service personnel.
WARNING: THIS WARNING IS APPLICABLE FOR OTHER
COUNTRIES.
1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts that
conforms to the safety regulations of each country if
applicable.
2. Use the Power Cord (3-core mains lead) / Appliance
Connector / Plug conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the above Power Cord /
Appliance Connector / Plug, please consult a qualified service
personnel.
About the NETWORK TRUNK connector
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following ports.
: NETWORK TRUNK connector
: LAN connector
• When you connect the LAN cable of the unit to peripheral
device, use a shielded-type cable to prevent malfunction
due to radiation noise.
About the LAN connector
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following ports.
: NETWORK TRUNK connector
: LAN connector
• When you connect the LAN cable of the unit to peripheral
device, use a shielded-type cable to prevent malfunction
due to radiation noise.
For kundene i Norge
Dette utstyret kan kobles til et IT-strømfordelingssystem.
This HD Camera Control Unit is classified as a CLASS 1
LASER PRODUCT.
Dieses HD-Kamera-Steuergerät ist als LASERPRODUKT
DER KLASSE 1 eingestuft.
Tämä HD-kameraohjausyksikkö on luokiteltu 1. LUOKAN
LASERTUOTTEEKSI.
Den här kontrollenheten för HD-kamera klassificeras som en
LASERPRODUKT AV KLASS 1.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
CAUTION
The use of optical instruments with this product will increase
eye hazard.
GB
11