Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig . A) - Parkside PLG 20 A1 Originalbetriebsanleitung

Safety guidelines for battery chargers

This appliance may be used by
■
children aged 8 years and
above and by persons with lim-
ited physical, sensory or mental
capabilities or lack of experience
and knowledge, provided that
they are under supervision or
have been told how to use the
appliance safely and are aware
of the potential risks . Do not
allow children to use the appli-
ance as a toy . Cleaning and user
maintenance tasks may not be
carried out by children unless
they are supervised .
To avoid potential risks, dam-
■
aged mains cables should be re-
placed by the manufacturer, their
customer service department or
a similarly qualified person .
The charger is suitable for indoor use
only .
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
■ 12 │ GB │ IE

Before use

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket . The control
LED lights up red .
♦ The green control LED
charging process is complete and the battery
pack is ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
broken .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes be-
tween successive charging sessions . Also discon-
nect the power plug from the mains power socket .
PAP 20 A1 + PLG 20 A1
to the high-speed
(see fig . A) .
indicates that the
flashes, this means
has overheated and
both
into the appliance .
is