Installing The Printer Software On Windows; Installing On Windows 2000 - Epson IEEE 1394 Handbuch

Installing the Printer Software on Windows

To install the printer software included on the "Printer Software for
EPSON Stylus PRO 10000/10000CF" CD-ROM shipped with your
printer, follow the sections below.

Installing on Windows 2000

1. Make sure that your printer is off and connected to your computer.
2. Turn on your computer and start Windows. If the New Hardware
Found screen or any other Wizard appears, click Cancel.
3. Insert the printer software CD-ROM shipped with your printer in
the CD-ROM drive. The Installer dialog box appears.
If the dialog box does not appear, click Start and Run. Then, type
D:\SETUP and click OK. (assuming your CD-ROM drive is D. If it is
another drive, use that drive letter instead.)
4. Choose your printer, then click the right arrow in the Installer dialog
box.
Click Install Printer Driver/Utility, then the right arrow, and then OK
5.
in the dialog box that appears to start the printer software
installation.
6. Turn on your printer when the installation program asks you to turn
it on.
7. When Windows 2000 detects the printer, Found New Hardware
Wizard will be displayed. Click Next.
Note:
If an error message is displayed, or the Found New Hardware Wizard is
not displayed, the printer has not been detected normally by Windows 2000.
In this case, check the IEEE 1394 port settings under Windows 2000, your
cable connections, and the printer power.
8. Select Search for a suitable driver for my device.
(recommended), and then click Next.
6