Herunterladen Inhalt Inhalt Diese Seite drucken

Introduction; Intended Use; Equipment - Parkside PPS 40 A1 Bedienungs- Und Sicherheitshinweise

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 85
Plasma cutter PPS 40 A1

• Introduction

Congratulations! You have
purchased one of our high-quality
products. Please familiarise yourself
with the product before setup or first use.
Please also read the safety instructions
carefully. This product must be set up or used
only by people who have been trained to
do so.
Keep out of the reach of children!
PLEASE NOTE!
fThe use of the term 'product'
or 'device' in the following text refers
to the plasma cutter named in these
operating instructions.

• Intended use

The device is intended for compressed-air
plasma cutting of all electrically conductive
metals. Observing the safety instructions
and assembly instructions and operating
information in the instructions for use is also
a component of intended use.
It is imperative to adhere to the applicable
accident prevention regulations. The device
must not be used:
in insufficiently ventilated rooms,
in moist or wet environments,
in explosive environments,
to defrost pipes,
in close proximity to people
with cardiac pacemakers and
in close proximity to easily
flammable materials.
Use the product only as described and
only for the specific applications as stated.
Keep these instructions in a safe place.
Ensure you hand over all documentation
when passing the product on to anyone else.
Any use that differs to the intended use as
stated above is prohibited and potentially
dangerous. Damage or injury caused by
misuse or disregarding the above warning
is not covered by the warranty or any
liability on the part of the manufacturer.
RESIDUAL RISK
Even if you operate the device as intended,
there will be residual risks.
Following hazards may occur in conjunction
with the construction and design of this plasma
cutter:
Eye injuries due to glare,
Touching hot parts of the device
or workpiece (burn injury),
In case of improper protection risk
of accident and fire through sparks
and slag particles,
Harmful emissions from smoke and gases
if there is a lack of air or if closed rooms
are insufficiently extracted.
Reduce the residual risk by carefully using
the device as intended and observing all
instruction.

• Equipment

PLEASE NOTE!
f After unpacking the product, please
check that all of the package contents
are present and that the device is in
perfect condition. Do not use the device
if it is defective.
Introduction
GB/CY
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis