Husqvarna AUTOMOWER 105 Bedienungsanleitung Seite 16

®
• For Automower 315X/430X/450X: The
satellite symbol is shown when the GPS-
supported navigation is activated. Symbol
(A) is shown when the symbol has made
contact with a sufficient number of GPS
satellites. Symbol (B) shows when the
product has not made contact with a
sufficient number of GPS satellites.
Symbol (A) blinks during the first days the
product is working, as it is collecting GPS
information about the installation.
A
• The ECO symbol is displayed if the
ECO mode .
product is set in
• The black clock symbol (A) is shown
when the product is not allowed to mow
Schedule setting. If the product
due to a
is not allowed to mow due to
timer , symbol (B) is shown. If the
Override schedule is
operation mode
chosen, symbol (C) is shown.
A B
• The battery status shows the remaining
battery charge. If the product is loading, a
flash is also shown over the battery
symbol (A). If the product is placed in the
charging station without charging, (B) is
shown.
A
• The height adjustment setting is displayed
as a scale/numerical value.
®
• For Automower Connect@Home (refer
®
Automower Connect@Home on page
to
20 ): An icon for Bluetooth
communication will appear in the product
display when connection with your mobile
device has been established.
16 - Installation
3.6 Keypad Automower
305/310/315/315X/420/430X/440/450X
The keypad consists of 6 groups of buttons:
B
•
•
Weather
•
•
C
•
•
3.7 The indicator lamp Automower
305
The indicator lamp on the ON/OFF button is
an important status indicator:
B
•
•
•
®
wireless
®
The START button is used to activate the
product. This is normally the last button to
be pushed before closing the hatch.
The BACK and OK buttons are used to
navigate in the menu. The OK button is
also used to confirm settings.
The arrow button are used to navigate in
the menu but also to make selections in
certain setting options.
The MENU button is used to go to the
main menu.
The PARK button is used to send the
product to the charging station.
The number buttons are used to enter
settings, for example PIN code, time or
exit direction.
The product is active if the indicator lamp
lights continuously.
The product is in standby if the indicator
lamp flashes. This means that the
operator must push the ON/OFF button to
make the product active again.
The product is disabled when the
indicator lamp is not lit.
1418 - 001 - 04.12.2019
®