Battery Safety - Husqvarna AUTOMOWER 105 Bedienungsanleitung

• If the product starts to vibrate abnormally.
Always switch off the product with the
main switch or ON/OFF button and
inspect for damage before staring the
product again.
• Start the product according to the
instructions. When the product is enabled
with the ON/OFF button or when the main
1 make sure to keep your
switch is set to
hands and feet away from the rotating
blades. Never put your hands and feet
under the product.
• Never touch moving hazardous parts,
such as the blade disc, before it has
come to a complete stop.
• Never lift up the product or carry it around
when it is switched on.
• The product must never be allowed to
collide with persons or other living
creatures. If a person or other living
creature comes in the product's way it
shall be stopped immediately.
• Do not put anything on top of the product
or its charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body.
Neither should it be used with defective
blades, screws, nuts or cables. Never
connect a damaged cable, or touch a
damaged cable before it is disconnected
from the supply.
• Do not use the product if the main switch
or the ON/OFF button do not work.
• Always switch off the product using the
main switch or the ON/OFF button when
1418 - 001 - 04.12.2019
the product is not in use. The product can
only start when the main switch is set to
1 , or the ON/OFF button is switched on
and the indicator lamp is lit. The correct
PIN code must also be entered for the
product to start.
• The product must never be used at the
same time as a sprinkler. Use the
Schedule function so the product and
sprinkler never run simultaneously.
• Husqvarna does not guarantee full
compatibility between the product and
other types of wireless systems such as
remote controls, radio transmitters,
hearing loops, underground electric
animal fencing or similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled
indoors.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can
result in a stoppage. The metal objects
can cause interference with the loop
signal which then can lead to a stoppage.
• Operation and storage temperature is
0-50 °C / 32-122 °F. Temperature range
for charging is 0-45 °C / 32-113 °F. Too
high temperatures might cause damage
to the product.

2.3 Battery safety

WARNING:
can explode or cause fire if
disassembled, short-circuited,
exposed to water, fire, or high
temperatures. Handle carefully, do
not dismantle, open the battery or
use any type of electrical/
mechanical abuse. Avoid storage in
direct sunlight.
For more information about the battery, refer
Battery on page 22
to
Lithium-ion batteries
Safety - 13