Example Session - Dell PowerConnect M6220 Series Handbuch Zum Einstieg

• Sets up the SNMP community string to be used by the SNMP manager at a given IP address.
You may choose to skip this step if SNMP management is not used for this switch.
• Allows you to specify the management server IP or permit management access from all IP
addresses.
• Configures the default gateway IP address.

Example Session

This section describes an Easy Setup Wizard session. The following values are used by the example
session:
• The IP address for the management VLAN is 192.168.1.100:255.255.255.0.
• The user name is admin, and password is admin123.
• The network management system IP address is 192.168.1.10.
• The default gateway is 192.168.1.1.
• The SNMP community string to be used is Dell_Network_Manager.
The setup wizard configures the initial values as defined above. After you complete the wizard,
the switch is configured as follows:
• SNMPv1/2c is enabled and the community string is set up as defined above. SNMPv3
is disabled by default.
• The admin user account is set up as defined.
• A network management system is configured. From this management station, you can access
the SNMP, HTTP, and CLI interfaces. You may also choose to allow all IP addresses to access
these management interfaces by choosing the (0.0.0.0) IP address.
• An IP address is configured for the default management VLAN (1).
• A default gateway address is configured.
NOTE:
In the example below, the possible user options are enclosed in [ ]. Also, where possible, the
default value is provided in { }. If you press <Enter> with no options defined, the default value is accepted.
Help text is in parentheses.
The following example contains the sequence of prompts and responses associated with running
an example Dell Easy Setup Wizard session, using the input values listed above.
Getting Started Guide
11