English Gb - Honeywell HZ822E Betriebsanleitung

ENGLISH GB

IMPORTANT SAFETY INSTRUCTIONS
Read through all the instructions before
starting to use the appliance. Keep this manual in
a safe place for future reference.
These instructions are also available on our
website. Please visit www.hot-europe.com.
• This appliance must only be operated as
instructed in this user manual.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance.
• Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided
that it has been placed or installed in its
intended normal operating position and they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
aged from 3 years and less than 8 years shall
not plug in, regulate and clean the appliance or
perform user maintenance.
• CAUTION — Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
• Never position this appliance immediately
underneath a power socket.
• Do not use this heater in the immediate
surroundings of a bath, a shower or a
swimming pool.
• DO NOT COVER WARNING: In order to
avoid overheating, do not cover the heater
with anything, as indicated by the symbol. This
can lead to overheating, fire or electric shocks.
Ensure that the air intake and outlet vents are
not obstructed.
• The appliance is intended only for use indoors,
not for outdoor use or commercial use.
• Do not use the appliance anywhere near
easily flammable gases or substances such
as solvents, lacquers, glues, etc. Some of the
internal parts can be hot and could throw
sparks.
• Keep flammable materials at least 100cm
away from the heater. To prevent burns, do not
allow bare skin to come in contact with hot
surfaces.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
• Never touch the unit with wet hands.
• Check for any obstructions. If you find an
obstruction, turn off the heater using the
power button on the control panel. Allow the
heater to cool completely, then remove the
obstruction. Wait at least 10 minutes, then
turn on the heater and follow the instructions
for use.
CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through
an external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
COMPONENTS
(See page 2)
1. Air inlet grille
2. Air outlet grille
3. Turbo air outlet grille (HZ824E only)
4. Power setting knob with integrated pilot light
5. Thermostat knob
6. Handles
7. Feet
8. Feet assembly screws
9. Cable winding brackets
10. Power cable
ASSEMBLY
(See page 3)
This heater must be used with feet.
FOOTSTAND INSTALLATION
1. For floor use, attach the feet to the lower part of the heater by
snapping each foot into the matching holes (fig. 1).
2. As shown in fig. 1A, please tighten the feet at the bottom of the
heater using the feet assembly screws provided.
3. Place the heater on a firm, level, open surface at least 90cm away
from any other object. DO NOT use on an unstable surface such as
bedding or deep carpeting.
POWER CABLE WINDING
(See page 3)
• The heaters are equipped with brackets to wind the power cable when heater
is not in use. Those brackets are located on the bottom of the heater.
• Wind the power cable around the brackets (fig. 2).
4
• When you wish to use the heater, you must completely unwind the power
cable. An incompletely unwound power cable can lead to overheating
and cause a fire.
OPERATING INSTRUCTIONS
(See page 3)
A) MODEL HZ822E
• Turn the power setting knob counterclockwise to the (š) position.
• Plug the heater power cable into an outlet.
• Turn the power setting knob to the desired power setting (fig. 3):
= Low – 800W
= Medium – 1200W
= High – 2000W
• Turn the thermostat knob clockwise to the highest temperature setting
for rapid warming (fig. 3).
• When the room reaches a comfortable temperature, turn the thermostat
knob counterclockwise until the heater switches off (a click is heard and
the pilot light goes off). At this setting, the thermostat will automatically
turn the heater on (the pilot light illuminates) and off (the pilot light goes
out) to maintain the selected temperature.
• To turn the heater off, turn the power setting knob to the (š) position
and unplug the heater.
B) TURBO MODEL HZ824E ONLY
• Turn the power setting knob counterclockwise to the (š) position.
• Plug the heater power cable into an outlet.
• Turn the power setting knob to the desired power setting (fig. 4):
= Low – 1000W – for conventional heating
= Medium – 1500W – for conventional heating
= High with Turbo – 2500W – to be used for fast heating
• Turn the thermostat knob clockwise to the highest temperature setting
for rapid warming (fig. 4).
• When the room reaches a comfortable temperature, turn the thermostat
knob counterclockwise until the heater switches off (a click is heard and
the pilot light goes off). At this setting, the thermostat will automatically
turn the heater on (the pilot light illuminates) and off (the pilot light goes
out) to maintain the selected temperature.
• To turn the heater off, turn the power setting knob to the (š) position
and unplug the heater.
AUTOMATIC ANTI-FROST FUNCTION
The heater is equipped with an automatic anti-frost function. Plug in the
heater. Turn the power setting knob to any of the active settings ( , ,
). Turn the thermostat knob counterclockwise to its lowest setting,
indicated by the snowflake icon ( ). As soon as the room temperature
is below + 5° C the heater will automatically switch on. As the heater will
automatically turn on in anti-frost mode, make sure the heater is not covered
or obstructed by any object.
AUTOMATIC SAFETY CUT-OUT
This heater is equipped with an automatic safety cut-out. If the heater stops
unexpectedly, the safety cut-out may have operated. Once the safety cut-
out has operated, the heater will not restart until the heater has been turned
off and cooled down. In this situation, you must turn the power setting knob
to the (š) position and unplug the heater. Allow the heater to cool, then
follow the "Operating Instructions".
IF THE HEATER FAILS TO OPERATE
• Check for and remove any obstructions.
• Check if the heater is plugged in. Also check if the power socket is
working (e.g. plug in a different working electrical device).
• Make sure that the thermostat is not set too low. With the power setting
knob set to one of the active settings ( , , or ) turn the thermostat
knob clockwise until the heater turns on again (pilot light illuminates).
• If the heater still does not work, consult the warranty for further instructions.
CLEANING
We recommend you to clean the appliance twice a year (or before if you
notice performance to be impaired) with a vacuum cleaner.
1. Unplug the unit.
2. Allow it to cool down for 20 minutes.
3. Use a vacuum cleaner to suck out dust and dirt from both grilles.
ENGLISH GB
MAINTENANCE
In the event of overheating, the safety system will automatically turn off
the heating elements and/or the motor. If this happens please remove
any obstacles to the air outlet grille and clean the unit as indicated under
cleaning instructions.
DISPOSAL
This appliance complies with EU legislation 2012/19/EU on end
of life recycling. Products showing the 'Crossed Through' wheeled
bin symbol on either the rating label, gift box or instructions must
be recycled separately from household waste at the end of their
useful life.
Please DO NOT dispose of appliance in normal household waste. Your
local appliance retailer may operate a 'take-back' scheme when you are
ready to purchase a replacement product, alternatively contact your local
government authority for further help and advice on where to take your
appliance for recycling.
GUARANTEE
Please read all instructions before attempting to use this device. Please
retain the receipt as proof of and date of purchase. The receipt must be
presented when making any claim within the relevant guarantee period.
Any claim under the guarantee will not be valid without a proof of purchase.
Your device is guaranteed for three Years (3 Years) from date of purchase.
This guarantee covers defects in materials or workmanship that occur
under normal use; defective devices meeting these criteria will be replaced
free of charge.
The guarantee DOES NOT cover defects or damage resulting from abuse or
failure to follow the user instructions. The guarantee becomes void if the
device is opened, tampered with or used with other parts or accessories, or
if repairs are undertaken by unauthorised persons.
Accessories and consumables are excluded from any warranty.
For support requests, please visit www.hot-europe.com/support or find
service contact information at the end of this owner's manual.
This Guarantee is applicable to Europe, Russia, Middle East and Africa only.
UK Only: This does not affect your consumer statutory rights.
The LOT and SN of your device are printed on the rating label on the
packaging of the product.
CONDITION OF PURCHASE
or
As condition of purchase the purchaser assumes responsibility for the
correct use and care of this Helen of Troy product according to these user
instructions. The purchaser or user must himself or herself decide when
and for how long this Helen of Troy product is in use.
WARNING: IF PROBLEMS ARISE WITH THIS HELEN OF TROY
PRODUCT, PLEASE OBSERVE THE INSTRUCTIONS IN THE
GUARANTEE CONDITIONS. DO NOT ATTEMPT TO OPEN OR REPAIR
THE HELEN OF TROY PRODUCT YOURSELF, AS THIS COULD LEAD
TO TERMINATION OF THE GUARANTEE AND CAUSE DAMAGE TO
PERSONS AND PROPERTY.
This product carries the CE mark and is manufactured in conformity with
the Electromagnetic Directive 2014/30/EU, the Low Voltage Directive
2014/35/EU, the RoHS Directive 2011/65/EU and the Energy Using
Products Directive 2009/125/EC.
Technical modifications reserved
HZ822E
EHT822FUE
220-240V ~ 50Hz
2000W
HZ824E
EHT824FUE
220-240V ~ 50Hz
2500W
This product is only suitable for
well-insulated spaces or occasional use.
5