Introduction; Proper Use; Features And Equipment - Parkside POF 1300 Bedienungs- Und Sicherheitshinweise

Introduction

the following icons / symbols are used in this instruction manual:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Dangerous electric current – danger to life!
n
Rated idle running speed
0
V ~
Voltage
W
Watts (Effective power)
router POF 1300
Introduction
Q
Please make sure you familiarise your-
self fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. To help you do this please read
the accompanying operating instructions. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.

Proper use

Q
The device is intended for routing grooves, edges,
profiles and elongated holes and for copy routing
whilst resting firmly on wood, plastic and light con-
struction materials.
With a reduced rotational speed and the appropri-
ate router bits, the device can also be used to ma-
34 GB/MT
Safety class II
Wear hearing protection, dust protection mask,
protective glasses and protective gloves.
Keep children and other unauthorised personnel
at a safe distance when using electrical tools.
Keep the device away from rain or moisture.
Water entering an electrical device increases the
risk of electric shock.
Damaged appliances, power cables and power
plugs mean potentially fatal risks from electric
shock. Regularly check the condition of the appli-
ance, the power cables and the power plugs.
Dispose packaging and appliance in an
environmentally-friendly way!
chine non-ferrous metals. The device is not intended
for use in the open air. The device is not intended
for commercial use. Any other use or modification
to the device shall be considered as improper use
and could give rise to considerable dangers. The
manufacturer will not accept liability for loss or
damage arising from improper use.

Features and equipment

Q
Figure A, front of device:
Handle with ON / OFF switch
1
Spindle lock button
2
Spindle
3
Chip shield
4
Base plate
5
Guide plate
6
Step buffer
7
Dust boot
8
Stop screw for depth stop
9
Depth stop
10
Slider with index mark
11
Scale for coarse adjustment of depth of cut in mm
12
Scale for fine adjustment of depth of cut in mm
13