Table Of Pictograms Used Introduction; Intended Use - Parkside PDBN 6.3 A1 Bedienungs- Und Sicherheitshinweise

Table of pictograms used / Introduction
Table of pictograms used
Read the operating instructions!
Wear hearing protection,
a respirator/dust mask, safety
goggles and protective gloves!
Compressed air hose
Dispose of packaging properly.
Do not dispose of the appliance
in household waste!
Made from recycling material
AIR NIBBLER PDBN 6.3 A1
z Introduction
Congratulations! You have purchased one of
our high-quality products. Please familiarise
yourself with the product before setup or first
use. Please also read the safety instructions
carefully. This product must be set up or used
only by people who have been trained to
do so.
KEEP OUT OF THE REACH OF
CHILDREN!
6 GB
Important note!
Attention! Possible risks!
Never use hydrogen, oxygen,
carbon dioxide or any other
bottled gas as an energy
source!
Oil regularly!
Packaging material –
corrugated paper
z Intended use
The air nibbler is a tool powered by
compressed air for skilled manual work.
This is suitable for the cutting of sheet metal
(max. material thickness 1.2 mm), aluminium
(max. material thickness 1.6 mm), plastic,
leather and much more. With a air nibbler
it is possible to make wave-shaped, round,
straight and winding cuts in the material. The
operator must protect him/herself against
fragments with the use of safety goggles and
protective gloves for accidental contact with
any sharp edges.
Caution! This device may be used only
as specified herein. The stated material
thickness (cutting capacity) must not be
exceeded, this will damage your tool.