Trouble Shooting; Replacement Parts/Accessories - Parkside PRT 550 A1 Originalbetriebsanleitung

Trouble shooting

In the event of an accident or malfunction, disconnect the mains plug immediately!
Failure to comply may result in injuries from cuts.
Problem Possible cause
Appliance On/Off switch ( 2) defective
won't start
Motor defective
Intermittent Internal loose contact
operation
On/Off switch ( 2) defective
Cutting insert (
Much
vibration Trimming assembly dirty
Loud noise
Motor defective
The line spool (
not have enough cutting line
Bad trim
Both or one of the cutting
line is not protruding out of
the spool (

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 68). Please have the order number mentioned below ready.
15 Auxiliary handle .......................................................................91105340
20 Line spool ................................................................................13800132
9 Protective cover ........................................................................91105342
13) broken
20) does
20)
www.grizzly-service.eu
Corrective action
Send in to Service Centre for repair
Send in to Service Centre for repair
Replace cutting insert (
(see „Cleaning and maintenance")
Clean trimming assembly
(see „Cleaning and maintenance")
Send in to Service Centre for repair
If necessary, extend the cutting line (see
chapter "Device adjustments")
Replace the spool (
ing and Maintenance").
Remove the spool (
cutting line through the openings to the
outside, then reinstall the spool.
GB MT
13)
20) (see "Clean-
20) and feed the
69