Epson ELPIF02 Bedienungsanleitung Seite 7

Installing and Removing the Interface Board
Procedures and illustrations may di er depending on the projector you are using. For
details, see the "User's Guide" supplied with the projector.
Installing
You can install boards in Slot1 or Slot2 on the projector. After installing, make [SDI Set-
tings] from the projector's menu. For details, see the guides supplied with the projector.
Remove the slot cover.
A
Loosen the fixing screws (4 points) with a com-
mercially available No. 2 cross-head screwdriver,
and pull out the slot cover.
Store the removed slot cover in a safe place.
* The slot cover may not be attached depending
on the projector you are using.
Before replacing this product with another inter-
face board, make sure you remove the interface
board from the projector first.
➡ P. 8 - "Removing"
Make sure the interface board is not at an
B
angle, and insert it straight into the slot.
Push the interface board firmly into the slot until
it is fully inserted.
中
文
简
体
中
文
繁
體
7