Switching Off The Device; Overheat Protection; Troubleshooting; Maintenance, Cleaning And Storage - Parkside PHG 3000 D4 Bedienungs- Und Sicherheitshinweise

Initial use / Troubleshooting / Maintenance, cleaning and storage / Service

Switching off the device

Set the temperature control
To prevent heat from building up inside the unit,
allow the fan to continue running approx. 2 min
more before setting the heat switch
position.
To actually switch the device off, unplug the
mains plug to disconnect the heater fan from
the mains.

Overheat protection

This appliance is fitted with overheating protection.
If the device overheats, the heating element will au-
tomatically switch off. However, the fan will continue
to run to ensure fast cooling. The device will automat-
ically restart once it has cooled down accordingly.
ATTENTION! There typically is a reason
for overheating! It can indicate a fire
hazard!
Check if the device is able to emit heat adequate-
ly: is the device covered or too close to a wall
or another obstacle? Are the front and rear
grates clear? Has the fan jammed?
If possible, correct the problem or contact the
Service hotline (see chapter Service).
Even if you are unable to determine the cause
and the overheat protection is tripped again,
you will need to switch the device off and con-
tact the Service hotline (see chapter "Service").

Troubleshooting

Error Possible cause Solution
The device The mains plug
won't is not connected
switch on. to a socket.
The socket is not
supplying elec-
tricity.
back to MIN.
3
to the 0
2
Should problems arise whilst operating your ROWI
Electronics product, please proceed as follows:
1. Contact us
You may contact the ROWI Electronics Service
Team at:
ROWI Electronics GmbH
Insert the mains
Augartenstr. 3
plug into the
76698 Ubstadt-Weiher, Germany
mains socket.
Id-services@rowi-electronics.com
Check the fuses
Service hotline: +49 (0) 7253 9460-40
in the house.
Error Possible cause Solution
The device The heat switch
is not emit- is not on.
2
ting heat.
The temperature
control
3
to MIN.
Heating element
defective.
Maintenance, cleaning
and storage
Always disconnect the mains plug when the
device is not in use and before cleaning or in
the event of malfunctions!
Only clean the device when switched off and
cold.
Ensure no moisture enters the device during
cleaning to prevent damaging the device be-
yond repair.
O nly clean the housing with a slightly damp
cloth and mild washing-up liquid.
U se a vacuum cleaner to remove any dust on
the grate.
S tore the device in a dry location.

Service

Set the heat
switch to the
2
desired setting.
Set the temper-
is set ature control
3
to MAX.
Contact custom-
er service.
GB 9