Use; Switching On And Off; Setting The Speed - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Use
F or the best grinding performance move the
device evenly to and fro over the workpiece
maintaining an angle of 15° to 30° (between
grinding disc and workpiece).
W hen working on inclined surfaces do
not press the device hard down on to
the workpiece. If the speed slows greatly,
use less pressure. This will allow you to work more
effectively and safely. If the device suddenly
stops due to it becoming retarded or trapped,
pull the mains plug from the socket immediately.
C utting: Advance the device at an
appropriate rate. Do not incline the
cutting disc.
R oughing, grinding and cutting discs
get hot during use – allow them to
cool fully before touching them.
N ever use the device for a purpose
for which it was not intended.
B efore you insert the mains plug into
the socket, always check that the de-
vice is switched off.
I f a dangerous situation arises, pull
the mains plug immediately out of the
mains socket. Ensure that the device and
the mains plug are easily accessible and can
be reached quickly in an emergency.
W hen taking a break from your
work, before carrying out any tasks
on the device itself and when you are
not using the device, always pull the
mains plug out of the mains socket.
Always keep the device clean, dry and free of
oil or grease.
R emain alert at all times! Always watch
what you are doing and proceed with
caution. Do not use the device if you cannot
concentrate or you are feeling unwell.

Use

Q

Switching on and off

Q
Check the attached consumable or tool before use.
It must be attached properly, not damaged, damp
or cracked and must rotate freely. Test the operation
14 GB
of the device for 30 seconds. If a disc is not round
or vibrates, do not use it. Look out for unusual noises
or generation of sparks. Check that all the fastenings
are correctly attached.
Switching on:
P ress the safety lock-out
P ress the ON / OFF switch
Switching off:
R elease the ON / OFF switch

Setting the speed

Q
S elect the desired speed before use to suit your
purpose. Turn the speed preselector wheel
to the desired setting. The required rotational
speed depends on the material being worked
and the working conditions and can be deter-
mined by means of a practical test.
The table below shows some recommended
settings (for guidance only and given without
liability) for a number of common applications.
The accessories mentioned may not all be sup-
plied as standard with the product.
Preselected rotation speed:
Material Application
Plastic, Polishing
varnish
Fine finish
Metal Fine finish
Paint
removal
Wood, Brushing,
metal derusting
Metal Grinding /
abrading
Metal Roughing /
grinding
Metal Cutting
.
1
.
2
again.
2
10
Tool Setting
Lambswool 1
bonnet
Felt polishing 1
disc
Buffing disc 1
Sanding sheet 2–3
Cup brush, 3
sanding sheet
Grinding disc 4–6
Roughing / 6
grinding disk
Cutting disc 6