Maintenance; Storage; Transport; Waste Disposal And Environmental Protection - Parkside PTBM 500 E5 Originalbetriebsanleitung

GB MT
H

Maintenance

Repeat the maintenance after every
5 hours of operation.
1. Release the locking bolt (
gear cover (3).
2. Open the gear cover (3).
3. Release the retaining screw (
the motor unit (
4. Using the lever (
unit ( 13) forwards a little to release
A
the load on the V-belts (
5. Remove both V-belts (
6. Remove the middle drive disc (37) and
its retainer (38).
7. Clean the bearing point retainer
(39+40) and grease this with a
commercially available multi-purpose
grease.
8. Re-insert the retainer (38) and the drive
disc (37). Tighten the V-belts (
again.
9. Using the lever (
unit ( 13) backwards to re-tighten the
A
V-belts ( 29).
E
10.The V-belts (
E
oned when they give way slightly when
pressed.
11.Re-tighten the retaining screw (
of the motor unit (
12.Close the gear cover (3). Fasten the lo-
cking bolt ( 11) on the gear cover .
A

Storage

• Store the appliance in a dry place well
out of reach of children.
• The device can be relocated over a
short distance with two people. Reloca-
ting the device over a longer distance
generally has to take place with a trans-
port aid.
74
11) on the
A
12) on
A
13).
A
33), slide the motor
E
29).
E
29).
E
29)
E
33), slide the motor
E
29) are correctly tensi-
A
13).
A

Transport

Do not carry the bench drill
holding it on the motor unit.
If possible, carry the bench drill together
with another person. Grip the baseplate
( 17) with one hand and stabilise the
A
machine on the drive cover (
other hand.
Waste disposal
and environmental
protection
Be environmentally friendly. Remove the
battery from the device and take the de-
vice, battery, accessories and packaging
for environmentally friendly recycling.
Electrical machines do not belong
with domestic waste.
• Hand over the device at an utilization
12) location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implemented.
Ask our Service-Center for details.
• Dispose of batteries in accordance with
the local regulations. Take batteries to
an old battery collection point where
they will be recycled in an environmen-
tally friendly manner. For information
about this, ask your local waste manage-
ment company or our service centre.
• Defective units returned to us will be
disposed of for free.
Caution! Hot surface. There is a
risk of burns. Only transport the
machine when the motor unit
( 13) has cooled down com-
A
pletely.
3) with the
A