Instructions, Tips And Tricks; Maintenance And Cleaning - Parkside PSS 250 A1 Originalbetriebsanleitung

Vacuuming dust with the dust
collection box
Attach the dust collection box:
j
Push the dust collection box
remove the dust collection box:
j
Press the release button(s)
collection box off the device.
4
NOTE: Always empty the dust collection box
in due time and shake any remaining dust out; this
will ensure optimal vacuum performance.
Dust extraction using an external
vacuum extraction device
Connecting:
j
For vacuum dust removal using a vacuum
cleaner, push the suction hose of a vacuum
cleaner approved for use as a dust extraction
device (e.g. a workshop vacuum cleaner) into
the connection – see Fig. D.
5
NOTE: If it is necessary to use the reducer
piece , push the reducer piece into the con-
12
nection .
5
removing:
j
Pull the hose of the dust extraction device off
the connection or off the reducer piece
5
if one is used.

Instructions, tips and tricks

Q
j
Move the oscillating sander parallel, in flat
circles or alternating between lengthwise and
side-to-side motions.
j
Do not press down with the oscillating sander.
The sanding sheets become clogged, which
reduces the sanding performance.
j
Clean the sanding sheet
the vacuum cleaner.
j
The removal performance and therefore the
result of your work are determined by the correct
selection of the speed and sanding sheet
j
Never sand different materials with the same
sanding sheet (e.g. wood then metal).
9
on to the device.
4
and pull the dust
3
4
,
12
occasionally with
9
grit.
9
Operation / Maintenance and cleaning
The following table offers some values, which are
for information only and may simplify the selection
of a sanding sheet
9
.
Wood
Sanding of wood
Pre-sanding, e.g. of
rough, unplaned
beams and boards
Surface sanding
Fine sanding of hard
woods
Paints / Lacquers
Sanding of paint /
lacquer coats or
base coats such
as filler and
smoothing com-
pound
Sanding off paint
Sanding off primer
coats
Final sanding of base
coats before painting

Maintenance and Cleaning

Q
WArNING!
DANGEr OF INJUry! Before
performing any work on the appliance, disconnect
the power plug.
j
Clean the appliance regularly, preferably always
immediately after use.
j
Do not use any sharp objects for cleaning the
appliance. Never permit fluids to permeate
inside the appliance.
j
Use a cloth to clean the casing. Never use petrol,
solvents or cleansers that damage plastics.
A vacuum cleaner is required for thorough
cleaning of the appliance.
j
Ventilation openings must never be obstructed.
j
Remove adhering sanding dust with a brush.
Sanding sheet / Grit
40 - 240
40, 60
80, 100, 120
180, 240
Sanding sheet / Grit
40 - 320
40, 60
80, 100, 120
180, 240, 320
GB 11