Advanced Settings - Yamaha PDM-1 Bedienungsanleitung

Item Effect
Contrast
Less
Brightness
Darker
Colour
Less
Tint
(NTSC only)
Reddish
Sharpness
Less
Note:
In PICTURE, there is not a noticeable change even when contrast is increased with a bright picture or reduced with a
dark picture.

Advanced Settings

Item Effect
Black
extension
Less
W/B High R
Less
W/B High B
Less
W/B Low R
Less
W/B Low B
Less
Gamma
Down
Notes:
(1) Carry out "W/B" adjustment as follows.
A Adjust the white balance of the bright sections using the "W/B High R" and "W/B High B" settings.
B Adjust the white balance of the dark sections using the "W/B Low R" and "W/B Low B" settings.
C Repeat steps A and B to adjust.
Steps A and B affect each other's settings, so repeat each step in turn to make the adjustment.
(2) The adjustment values are memorized separately for each input mode (AV(S Video), Component, RGB and PC).
(3) The adjustment range values should be used as an adjustment reference.
Helpful Hint (
On the remote control unit, while the "Advanced settings" menu is displayed, if either the N button is pressed at any
time or the (ACTION button) is pressed during "Normalise", then all adjustment values are returned to the factory
settings.
Adjustments
Selects the proper brightness and
density for the room.
More
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Brighter
Adjusts colour saturation.
More
Adjust for nice skin colour.
Greenish
Adjusts picture sharpness.
More
Adjusts the dark shades of the image in gradiation.
More
Adjusts the white balance for light red areas.
More
Adjusts the white balance for light blue areas.
More
Adjusts the white balance for dark red areas.
More
Adjusts the white balance for dark blue areas.
More
2.0 2.2
Up
N
/
Normalise
Picture Adjustments
Notes:
(1) "Colour" and "Tint" settings cannot
be adjusted for "RGB" and "PC"
input signal modes.
(2) You can change the level of each
Function (Contrast, Brightness,
Colour, Tint, Sharpness) for each
Picture Menu.
(3) The setting details for normal,
dynamic and cinema respectively
are memorized separately for each
input mode (AV(S Video), Component,
RGB and PC) .
(4) The "Tint" setting can be adjusted
for NTSC signal only during "AV
(S Video)" input signal.
Details
2.5
Normalisation)
25