Additional Safety Advice For Compressed Air Tackers; Original Accessories/Attachments; Bringing Into Use; Connecting The Compressed Air Source - Parkside IAN 32999 Bedienungs- Und Sicherheitshinweise

Fastener driving tool safety / Bringing into use
pecially if you are using a ladder or
moving your body in an unusual way.
J
When at the workplace, always carry
the device by the handle and not
while the trigger is ready to operate.
J
Pay attention to workplace conditions.
Tacks could be driven right through a thin
workpiece or shoot off and endanger people
when you are working on edges and corners.
J
For your own safety, wear
suitable personal protective
equipment, such as ear and eye pro-
tection. The wearing of personal protective
equipment such as dust masks, non-slip safety
shoes, safety helmets or ear protectors, appro-
priate to the type of fastener driving tool used
and work undertaken, reduces the risk of injury.
Additional safety advice
for compressed air tackers
DANgEr OF INJUrY!
WArNINg!
Never exceed the maximum allowable working
air pressure of 7 bar. Use a pressure reducer
to set the working air pressure.
WArNINg! DANgEr OF INJUrY!
Never use oxygen or other combustible gas as
the energy source.
J
Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
J
Keep children and other
people away while you are
operating the fastener driv-
ing tool. Distractions can cause you to lose
control of the device.
J
remain alert at all times, watch what
you are doing and always proceed
with caution when working with the
fastener driving tool. Do not use the
fastener driving tool if you are tired
or under the influence of drugs,
alcohol or medication. One moment of
carelessness when using the fastener driving
tool can lead to serious injury.
J
Avoid placing your body in an unnat-
ural position. Keep proper footing
8 GB/IE/CY
and balance at all times. By doing this,
you will be in a better position to control the
fastener driving tool, especially in unforeseen
circumstances.
J
Disconnect the device from the compressed air
source before carrying out any repairs or main-
tenance of the device or moving it to another
location.
J
DANgEr OF INJUrY! Never use the device
if the trigger lock
7
removed. Otherwise you could become injured.
J
When removing the hose coupling, hold the
hose tightly in your hand to avoid injury
caused by the hose shooting backwards.
J
Always use a threaded plug-in nipple ¼'' and
a quick release coupling for the compressed
air connection.
J
Never place your hands near the opening
while the device is ready to operate. Other-
wise you could become injured.
J
Look out for damage on the device.
Check the device for damage before bringing
it into use. Do not use the device if you discover
any defects.
J
Do not use pointed implements. Never
poke pointed and/or metal objects into the
interior of the device.
Original accessories/
Q
attachments
J
Use only the accessories and attach-
ments detailed in the operating
instructions. The use of driven fasteners or
accessories other than those recommended in
the operating instructions could lead to you
suffering an injury.

Bringing into use

Q
Connecting the
Q
compressed air source
NOTE: Operate the compressed air tacker only
with cleaned, oiled compressed air and never exceed
the maximum working air pressure at the device of
is defective or has been