Original Accessories/Attachment; Bringing Into Use; Connecting The Compressed Air Source; Using Compressed Air Tyre Inflator Gauge - Parkside PDSS B2 Bedienungs- Und Sicherheitshinweise

Original accessories/

attachments
Use only the accessories and attachments
detailed in the operating instructions. The use
of accessories other than those recommended in
the operating instructions could lead to you being
in danger of injury. Always have your air-powered
tool repaired by a professional using only original
spare parts.

Bringing into use


Connecting the compressed air

source
NOTE: Operate the product only with cleaned, conden-
sate- and oil-free compressed air and never exceed the
maximum working air pressure at the device of 8 bar.
NOTE: The compressed air source must be fitted with
a (filter)/pressure reducer so that the air pressure can
be regulated.
Connect the product to a suitable compressed air
source by connecting the quick-release coupling
of the air supply hose with the plug-in nipple
to the product. It locks itself in place automatically.
Using compressed air tyre

inflator gauge
1. Place the valve connector
(Schrader valve (see Fig. A), e.g. often used on
mountain bikes).
2. Press the trigger to start the delivery of air.
6
3. Release the trigger
6
Read off the filling pressure on the gauge
4. If the object is overfilled with air (air pressure too
high): Press the deflator valve
air.
5. Press the lever of the valve connector
nwards and pull the valve connector
valve.
6. After you finish work, disconnect the device from
the compressor.
16 GB/IE
2
on to the valve
5
to stop the delivery of air.
.
1
to release some
3
dow-
5
off the
5
NOTE: First disconnect the hose from the compressor
and only then disconnect the compressed air supply
hose from the device. This will ensure that the com-
pressed air supply hose does not wave around in an
uncontrolled manner.
Using accessories:
Press the lever of the valve connector
sert the desired accessory
for adapter
9
connector
5
cycle tyre valve; (Dunlop valve (see Fig. C),
traditional cycle tyre valve).
Fig. A
Schrader valve
TIP: Use the valve adapter
valves shown.
4

Using air blow gun


1. Screw an extension nozzle
gun .
7
2. Press the trigger
3. Release the trigger
4. After you finish work, disconnect the device from
the compressor.
NOTE: First disconnect the hose from the compressor
and only then disconnect the compressed air supply
hose from the device. This will ensure that the com-
pressed air supply hose does not wave around in an
uncontrolled manner.
5
to or the cap
10 13
, and into the valve
14 15 16
(Presta valve (see Fig. B), e.g.
Fig. B Fig. C
Presta valve Dunlop valve
for the cycle tyre
13
7
on to the air blow
8
to start the delivery of air.
6
to stop the delivery of air.
6
and in-