Parkside PPS 40 A1 Originalbetriebsanleitung Seite 18

Troubleshooting
Sparks fly
upwards,
instead of down
through the
material?
Initial cut but not
completely drilled
through?
Slag formation
on interfaces?
Arc stops during
cutting?
Insufficient
penetration?
18 GB
Plasma pistol does not
„
penetrate the material.
Pistol too far away from
„
the material.
Apparently material was
„
not grounded properly.
Lifting speed is too quick.
„
Potential connection problem.
„
Tool/material creates heat.
„
Cutting speed too low
„
or current too high.
Individual parts of the pistol
„
are worn.
Cutting speed too low.
„
Pistol is held too high and too
„
far away from the material.
Individual parts of the pistol
„
are worn.
Workpiece no longer
„
connected to the grounding
cable.
Cutting speed too fast.
„
Pistol is not straight.
„
Metal is too thick.
„
Individual parts of the pistol
„
are worn.
Increase the current.
„
Reduce the distance between
„
the pistol and material.
Check the connection
„
for correct grounding.
Reduce the speed.
„
Check all connections.
„
Allow the material to cool
„
down and then continue
cutting.
Increase the speed and/or
„
reduce the current until the
slag has been reduced to
a minimum.
Check and replace worn
„
parts.
Increase the cutting speed until
„
the problem no longer exists.
Lower the pistol to the
„
recommended height.
Check and replace worn
„
parts.
Check the connections.
„
Slow down the working
„
speed.
Adjust the inclination.
„
Several cycles necessary.
„
Check and replace worn
„
parts.