Hitachi PC-ALH Installations- Und Betriebshandbuch Seite 9

7. Attach the receiver kit in the following procedure.
 D raw out the connecting cable from the pocket and connect the connecting cable and the wire of the receiver kit. After
connecting the cable, wrap the connector with the cover and fix them with a band.
 Hook the band on the rear side of the
receiver kit at the pin of the air panel
as shown bellow.
Band
8. Hook other fixing nails (3 positions) at square holes of air panel.

NOTE:
When removing the receiver kit after installing the air panel.
a) The corner position of the receiver kit can
be lifted when a coin or a "-" shaped driver
is inserted into the dent part
downward. With
"-" shaped driver at the positions of

b) After disconnecting the fixing nails (3
positions), slide the receiver kit in the arrow
direction
PMML0174A_r0_11-07.indb 9
INSTALLATION OF WIRELESS RECEIVER KIT
Air panel
Corner pocket
Connecting cable
Receiver kit
Pin
 and twisted
lifted, twist a coin or a

, the whole receiver kit can be lifted.
 , and remove the receiver kit.
Connecting cable
 H ook L- shaped nail on the rear side of
receiver kit at the square hole of the air panel.
L-Shape hook
Hook (3 locations)

 and

Band
Cover
Band

Coin or a "-" Shaped driver

Lifting
Dent part

22/11/2007 12:49:37