Hitachi PC-ALH Installations- Und Betriebshandbuch Seite 11

6. Remove the remote control cover of the air intake grille.
Press the hooks of the remote control cover by hand.
−
Remote
Control Cover
7. After fixing the air panel, attach the air intake grille to the air panel.
Check to ensure that the location of square hole of the air intake grille coincides with location of the wireless receiver kit
−
of the air panel.
Check to ensure that the cable of the wireless receiver kit is not clamped by the square hole of the air intake grille.
−
PC-ALHZ


NOTE:
Install the receiver kit onto the wall or ceiling near the indoor unit.
1. Install the wireless receiver kit and indoor unit at the
same time.
2. In case that the wireless receiver kit is installed after
installing the indoor unit, turn off the power source of
the indoor unit.
3. Check to ensure that the distance between the wireless
receiver kit and the indoor unit is less than 5 m.
4. Remove the cover by using minus screw-driver.
PMML0174A_r0_11-07.indb 11
INSTALLATION OF WIRELESS RECEIVER KIT
Hook
Hook
Remote
Air intake grille
Control Cover
Air intake grille
Air intake grille
Remote
Control Cover
Air panel
Wireless receiver kit
11
22/11/2007 12:49:40