Instructions, Tips And Tricks; Maintenance And Cleaning - Parkside PSS 250 A1 Bedienungs- Und Sicherheitshinweise

Vacuuming dust with the dust
collection box
Attach the dust collection box:
Push the dust collection box
Remove the dust collection box:
Press the release button(s)
collection box off the device.
4
NOTE: Always empty the dust collection box
in due time and shake any remaining dust out; this
will ensure optimal vacuum performance.
Dust extraction using an external
vacuum extraction device
Connecting:
For vacuum dust removal using a vacuum
cleaner, push the suction hose of a vacuum
cleaner approved for use as a dust extraction
device (e.g. a workshop vacuum cleaner) into
the connection – see Fig. D.
5
NOTE: If it is necessary to use the reducer
piece , push the reducer piece into the con-
12
nection .
5
Removing:
Pull the hose of the dust extraction device off
the connection 5 or off the reducer piece
if one is used.
©

Instructions, tips and tricks

Move the oscillating sander parallel, in flat
circles or alternating between lengthwise and
side-to-side motions.
Do not press down with the oscillating sander.
The sanding sheets become clogged, which
reduces the sanding performance.
Clean the sanding sheet
the vacuum cleaner.
The removal performance and therefore the
result of your work are determined by the correct
selection of the speed and sanding sheet
Never sand different materials with the same
sanding sheet (e.g. wood then metal).
9
on to the device.
4
and pull the dust
3
4
12 ,
occasionally with
9
9 grit.
Operation / Maintenance and Cleaning
The following table offers some values, which are
for information only and may simplify the selection
of a sanding sheet
9
Wood
Sanding of wood
Pre-sanding, e.g. of
rough, unplaned
beams and boards
Surface sanding
Fine sanding of hard
woods
Paints / Lacquers
Sanding of paint /
lacquer coats or
base coats such
as filler and
smoothing com-
pound
Sanding off paint
Sanding off primer
coats
Final sanding of base
coats before painting
©

Maintenance and Cleaning

DANGER OF INJURY! Before
WARNING!
performing any work on the appliance, disconnect
the power plug.
Clean the appliance regularly, preferably always
immediately after use.
Do not use any sharp objects for cleaning the
appliance. Never permit fluids to permeate
inside the appliance.
Use a cloth to clean the casing. Never use petrol,
solvents or cleansers that damage plastics.
A vacuum cleaner is required for thorough
cleaning of the appliance.
Ventilation openings must never be obstructed.
Remove adhering sanding dust with a brush.
.
Sanding sheet / Grit
40 - 240
40, 60
80, 100, 120
180, 240
Sanding sheet / Grit
40 - 320
40, 60
80, 100, 120
180, 240, 320
GB/MT 41