Configuring Signal Processing - Monacor DSM-26LAN Bedienungsanleitung

[1]
Fig. 17 Configuration window in the view MAIN, DSM-48...

7.3 Configuring signal processing

ATTENTION Combined with the control program, the signal pro-
cessor is an effective tool for making very detailed but
also major changes to the transmission properties of
the PA system .
Therefore, each modification to the parameters
should be performed with care and expertise . At the
worst, extreme changes to the settings may damage
the speakers .
To configure a unit, click the button
priate row of the list .
The configuration window (fig . 17) with the view MAIN for the
unit selected will appear . The colour field on the left-hand side, next
to LINK [4] , will indicate the connection status of the unit . When the
[13]
Fig. 18 View IN 1, DSM-48...
34
[2]
[3]
[4]
[5]
[11]
[12]
☞
( figs . 15, 16) in the appro-
[14]
[16] [17] [18] [19]
[21] [22]
[7]
[6] [8]
[9] [10]
colour field is green, a data connection has been established . A red
field will indicate that the connection has been interrupted and that
it is not possible to modify settings . If the user tries to make changes,
an error message will appear .
Any settings changed on the screen will be instantly transferred
to the unit provided that a data connection exists . The settings can be
saved as presets on the computer and the unit (
addition, it will be possible to define if the unit, when being switched
on, is to load a specific preset or the state it was in when switched
☞
off ( chapter 7 .7 ) .
To go to the other views (X-OVER, IN 1 – 2/4 , OUT 1– 6/8 ;
figs . 18 – 20 ), use the buttons on the side bar [1] . To return to the
main view, click the button MAIN .
[20]
[23]
[25]
[27]
[24]
☞
chapter 7 .3 .2) . In
[15]
[26]
[28] [29]