Parkside PKS 1700 B2 Originalbetriebsanleitung Seite 43

when changing accessories such as blades,
bits and cutters.
•
Remove adjusting keys and wrenches
– Form the habit of checking to see that keys
and adjusting wrenches are removed from
tool before turning it on.
•
Avoid unintentional starting
– Don't carry plugged-in tool with finger on
switch. Be sure switch is off when plugging in.
•
Outdoor use extension cords
– When tool is used outdoors, use only exten-
sion cords intended for use outdoors and so
marked.
•
Stay alert
– Watch what you are doing. Use common
sense. Do not operate tool when you are
tired.
•
Check damaged parts
– Before further use of the tool, a guard or
other part that is damaged should be care-
fully checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting,
and any other conditions that may affect its
operation. A guard or other part that is dama-
ged should be properly repaired or replaced
by an authorized service center unless other-
wise indicated elsewhere in this instructions
manual. Have defective switches replaced by
an authorized service center. Do not use tool
if switch does not turn it on and off.
•
Warning
– The use of any other accessory or attach-
ment other than recommended it this ope-
rating instruction or the Einhell catalog may
present a risk of personal injury.
•
Have your tool repared by an expert
– This electric appliance is in accordance with
the relevant safety rules repairing of electric
appliances may be carried out only by ex-
perts otherwise it may cause considerable
danger for the user.
•
Connect the dust extraction device
Wherever there are facilities for fitting a dust
extraction system, make sure it is connected
and used.
Anl_4300685.indb 43 Anl_4300685.indb 43
GB
2.2 Special safety information on the
equipment
1. Safety precautions
•
Change a worn out table insert.
•
Use only blades which are recommended by
the manufacturer and comply with EN 847-1.
•
If necessary, wear suitable personal protec-
tion equipment. This could consist of:
- Ear plugs to prevent the risk of damaging
your hearing
- A breathing mask to avoid the risk of inha-
ling hazardous dust
- Always wear gloves when handling saw
blades and rough materials. Whenever
practicable, saw blades must be carried in a
container.
•
The following can have an influence on dust
development:
- Worn, damaged or cracked saw blades
- Recommended capacity of the vacuum ext-
raction system: 20 m/s
- Proper guidance of the workpiece
•
Blades made of high-alloy high-speed steel
(HSS) must not be used.
2. Safety information on the laser
Important:
Laser radiation
Do not look into the beam Laser class 2
Protect yourself and your environment from ac-
cidents by taking the appropriate precautionary
measures.
•
Do not look directly into the laser beam with
the naked eye.
•
Never look directly into the laser path.
•
Never direct the laser beam at reflecting sur-
- 43 -
08.10.12 17:23 08.10.12 17:23