Changing The Engraving Point; Advice On Use - Parkside PGG 15 A1 Originalbetriebsanleitung

Operation

Changing the engraving point

performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point is released.
5
Remove the spring and the plain washer.
Push the plain washer and spring on to a new engraving point
Then insert this and turn the engraving point holder
to lock the engraving point in position.
Ensure that the engraving point

Advice on use

You can use the mini-engraver to produce creative, individual engravings.
For example, you can use it to place identifying marks on your valuables.
You can engrave numbers and letters into metal, glass, wood, plastic,
ceramic, stone and leather. This is done with the help of the supplied
engraving stencils
Hold the device at an angle, as you would a pencil.
Your arm should rest on the table.
Using very light pressure, guide the engraving point
workpiece. Find the ideal speed of movement by trial and error on
a piece of waste material.
14 GB/IE/CY
RISK OF INJURY! Switch the device off before
5
anticlockwise until the engraving
6
, see Figs. A and B.
7
as soon as it becomes too worn
is properly fixed in position.
5
.
5
clockwise
6
over the
5