Operation
Never use the device for a purpose for which it was not intended or
with non-original parts / accessories. The use of tools or accessories
other than those recommended in the operating instructions could lead
to you suffering an injury.
Switching on / off
Insert the mains plug into a mains socket.
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
Setting the cutting depth
The cutting depth of the engraver is set using the stroke rate rotary control-
ler
. A low setting is usually sufficient for most common applications.
2
Turn the stroke rate rotary controller
crease the cutting depth.
Turn the stroke rate rotary controller
Note: Take care when increasing the cutting depth not to turn the stroke
rate rotary controller
could screw off the device.
.
1
.
1
too far towards the + sign. Otherwise the switch
2
towards the + sign to in-
2
-
towards the
2
GB/IE/CY
Operation
depth.
13