Electrical Safety; Start-Up - Parkside PHD 150 C2 Originalbetriebsanleitung

GB IE CY
check that the required electrical pro-
tection measures are in place.
• Do not operate the equipment if the
mains cable, water supply or other im-
portant parts such as the high-pressure
hose or gun are damaged/leaking.
• Protect the pressure cleaner from frost
and dry running.
• High-pressure hoses, fittings and
couplings are important for machine
safety. Use only high-pressure hoses,
fittings and couplings recommended by
the manufacturer.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an authorised electrician.
In the case of repairs, always contact
our service centre.

Electrical safety:

Caution: to avoid accidents
and injuries from electric
shocks:
• The plug and socket of an extension
cable must be water-tight!
Unsuitable extension cables can
be dangerous as people can be
harmed by an electric shock!
• Protect the electric plug connections
against moisture.
• If there is a risk of flooding, fix the
plug connections in an area that is safe
from flooding.
• Ensure that the mains voltage matches
the specifications on the rating plate.
• Connection to the mains must be
carried out by an experienced electri-
8
cian and meet the requirements of
IEC 60364-1.
• The electrical installation shall be ac-
cording to national wiring rules.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
Fuse: at least 13 ampere.
• Before each use, check the equipment,
cable and plug for damage.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of the power sup-
ply cable must not be less than
2 x 2,5 mm².
• Wear sturdy footwear to protect
against electric shock.
• To protect against electric shock, oper-
ate the equipment only in an upright
position.

Start-up

In keeping with current regulations
a pressure cleaner must never be
operated off the drinking water
mains supply without a controllable
backflow preventer. A suitable back-