baltur RiNOx 60 L2 Bedienungsanleitung Seite 33

MAINTENANCE
Most components can be inspected by removing the hood. To inspect the head you must disassemble the component-carrying plate
which can be hung on hung on the burner body in two different positions to make work as practical as possible.
The motor, transformer and solenoid valve are connected via a connector while the photo-resistor is push-locked into place.
At the end of the heating season, it is good practice to clean the filter, the combustion head (disk, insulator, electrodes, nozzles, the
combustion air passage and the photoresistant cell. It is advisable to use wood or plastic instruments to clean the nozzle passages.
Nozzles should be replaced after 12 months' use.
1) Undo the lid screw to gain access to the interior of the burner.
2) Undo the 4 screws of the plate, as indicated, in order to access
nozzle, electrodes and pre-heater (if fitted).
3) The plate must be hung up as illustrated in fig. C.
13 / 18
0006080925_201110