Changing The Attached Tool - Parkside PMFW 280 A2 Originalbetriebsanleitung

Materials:
Sheet and tube up to approx. 3 mm made of
aluminium, copper
Use:
· Cutting and trimming to length of tube and sheet
(see Figs. J)
Plunge saw blade (32 mm) Z32 A2
Materials:
Wood, plastic, plasterboard and other soft materials
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Sawing of recesses in lightweight walls.
(see Figs. B and D)
Backing plate
7
Materials:
Wood (sanding sheets included), paint*, stone*
*depending on the sanding sheet
Use:
· Sanding at edges and in difficult to access areas
(see Figs. G and H)
Segment saw blade Z85 A2
6
8
Material:
Wood, metal
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
Scraping knife Z52 A2
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)

Changing the attached tool

Q
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
"Connecting a vacuum dust extraction device").
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
R emove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
11
P lace the tool (e.g. plunge saw blade
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
F asten the tool in place with the clamping
screw and clamping plate
10
clamping screw
10
Assembly
9
using the Allen
10
) on
6
. Tighten the
4
using the Allen key .
11
GB/IE/CY 11