Switching On And Off; Selecting The Correct Rotational Speed And Sanding Belt - Parkside PBS 600 A1 Originalbetriebsanleitung

Dismantle / remove the dust box:
P ress the release button
and withdraw it towards the rear of the device.
Adapter for external vacuum extraction
(with reducer piece)
connection:
P ush the adapter for external vacuum extraction
into the adapter port
12
use the reducer piece
into the adapter for external vacuum extraction
S lide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12
if used.
Removal:
P ull off the dust extraction device hose.
P ull off the adapter for external vacuum extrac-
tion (with the reducer piece
12
Operation
Q

Switching on and off

Q
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
P ress the ON / OFF switch
To switch off intermittent operation mode:
R elease the ON / OFF switch
To switch on continuous operation mode:
P ress the ON / OFF switch
pressed, then press the locking knob
To switch off continuous operation mode:
P ress and then release the ON / OFF switch
of the dust box
6 5
. If it is necessary to
9
, push the reducer piece
13
12
with the reducer piece
13
, if used).
13
3
.
3
.
, and keep it
3
4
.
3
Preparing for use / Operation
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel even whilst the sander is running.
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
.
Material / type of
work
Coarse finish
,
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
.
Fine finish (Grit grade) ––
Preselected rotation
speed
Softwood
60
high (5-6)
Hardwood
60
high (5-6)
chipboard
60
high (5-6)
Removing paint /
varnish
60
high (5-6)
GB 21