Herunterladen Inhalt Inhalt Diese Seite drucken

Switching Off; Solder Sponge; Soldering - Parkside PLS 48 B1 Bedienungs- Und Sicherheitshinweise

Regelbare lötstation
Vorschau ausblenden Andere Handbücher für PLS 48 B1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 87
Setting 5 = 500 °C maximum soldering temperature, e.g. for desolder-
ing large soldered joints

Switching off:

Note: After use always replace the soldering pencil
Press the ON / OFF switch
If the device is not being used, pull the mains lead out of the mains
socket.

Solder sponge

Q
CAUTION! The hot soldering tip
contact with a dry solder sponge
may be damaged.
The solder sponge
Moisten the solder sponge

Soldering

Q
— The soldering pencil has a rated output of 48 watts and is therefore
ideal for electronics soldering (see Figs. A, B).
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
Clean the soldering tip
After cleaning the tip
This is done by melting solder on to the hot soldering tip
Guide the soldering tip
Place the solder (with flux) between the joint site and the tip
to melt it.
into setting "0".
2
7
5
is used to clean soldering tips.
5
before you use it.
5
on the moist solder sponge
7
it must be "tinned" (coated with solder).
7
to the intended joint site and heat the joint.
7
Using the product
into the holder.
1
must never be placed in
, otherwise the solder sponge
.
5
.
7
7
GB
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis