Accepting An Incoming Bluetooth Connection Request/Ending A Call; Taking An Incoming Call; Selecting A Connected Device On The Ext In/Out Terminals; Enabling Or Disabling The Bluetooth Function - Yamaha YVC-300 Benutzerhandbuch

Accepting an incoming
Bluetooth connection request/
ending a call
The product can work with the phone function of
the Bluetooth-connected smartphone.

■ Taking an incoming call

When the Bluetooth-connected smartphone gets
an incoming call, the microphone indicator flashes
green (red if the microphone is muted) (at 0.25-
second intervals).
By pressing the on/off-hook button (
incoming call is received, you can talk with the
remote party through the microphone and speaker
of the product. The on/off-hook indicator lights up
green during the call.
Note
Some smartphones may enable the microphone and
speaker on them after they get an incoming call. To
resolve this situation, select YVC-300 in the audio source
settings of the smartphone to enable the microphone
and speaker of the product.
■ Ending a call
Press the on/off-hook button (
on/off-hook indicator turns off and the call is ended.
Selecting a connected device
on the EXT IN/OUT terminals
The EXT IN/OUT terminals of the product are
available for two purposes: for connecting the
products and for connecting a videoconference
system.
Based on the device for connection, follow the
steps below to switch the setting:
1 Press and hold the both volume
buttons ( ) simultaneously for at
least 2 seconds.
A notification sound rings, and the
microphone indicator flashes white.
2 Press the volume button (
) while the
3 Press and hold the both volume
) during a call. The
When not using a Bluetooth connection, you
can disable the Bluetooth function.
To use a Bluetooth connection again, enable the
Bluetooth function.
1 Press and hold the both volume
2 Press the Bluetooth button (
set the volume level indicator display
so that the device to be connected is
selected.
Example ( ● : On, ○ : Off)
YVC-300 daisy chain
●○○○○
connection
Videoconference system
○●○○○
Tip
The factory setting is set to "YVC-300 daisy chain
connection".
buttons ( ) simultaneously for at
least 0.5 seconds.
A notification sound rings when the setting is
applied. The microphone indicator goes
back to the previous state, lighting up green
or flashing red.
Enabling or disabling the
Bluetooth function
buttons ( ) simultaneously for at
least 2 seconds.
A notification sound rings, and the
microphone indicator flashes white.
enable or disable the function.
The Bluetooth indicator that lights up green
indicates that the function is enabled, and
the indicator that is off indicates that the
function is disabled.
YVC-300 User's Manual
) and
) to
31