Epson ELPMB47 Bedienungsanleitung Seite 22

v Always follow the instructions below when installing the ceiling mount. If installation work
is not carried out correctly, the projector and ceiling mount could fall and cause injury.
• Check the structure and materials of the mounting location and use the most appropriate
construction method.
• Do not hang or mount anything except the specified projector from or on the ceiling mount.
The projectors that can be mounted on this ceiling mount are listed in the catalogs.
• Do not hang from the ceiling mount or apply excessive force to it during or after installation.
• Tighten the screws firmly. Also, never loosen or remove any screws carelessly when mounting
or removing the ceiling mount.
• Never disassemble or remodel the ceiling mount unless indicated in this manual.
v Install the supplied safety wire to prevent the projector from falling.
The safety wire also prevents the projector from swaying during an earthquake or vibration.
sp.31
v Applying a screw-locking adhesive, lubricant, oil or other substance to the points at which
the projector is fixed to the ceiling mount can make the case crack and the projector fall,
leading to damage or injury. Do not use any sort of adhesive, lubricant or oil when
installing or adjusting the ceiling mount.
v Never loosen any bolts, screws, or nuts after installation. Also, check periodically that no
screws have come loose. If you find a loose screw, tighten it firmly.
v Do not use the ceiling mount and refer all repairs to qualified service personnel under the
following conditions:
• The ceiling mount fell off or was broken before installation.
• The supplied parts have problems and do not work correctly.
v Unplug the projector before installing.
v Handle the power cord carefully.
Incorrect handling could cause fire or electric shock. Observe the following precautions when
handling:
• Do not handle the cord with wet hands.
• Do not use a cord that is damaged or modified.
v Do not install or use the projector in locations where it could be splashed with water such
as outdoors, in a bathroom or shower room, and do not install in locations subject to high
levels of humidity.
This could cause fire or electric shock.
v When cleaning, do not use a wet cloth or alcohol, benzine, thinner, and so on.
If water enters the projector, the casing may degrade and break which could cause an electric
shock.
v Do not strongly pull or pinch the projector's power cord during installation. Be careful
especially when passing the power code through the pole.
If the power cord is damaged, it could cause fire or an electric shock. Contact your dealer if the
wires of the power cord become exposed or broken.
22
Warning